ENGLISH
2. Verify Under-sink Mounting Location
Measure 22” from the base of the cabinet, and mark the mounting location for the top of the filter head. Measure 13” for the width required for the H 1200 System with dual cartridges. Make sure there is adequate space above the head to open and close the
DIMENSION | Width | Height | Depth |
13" | 22" | 5" |
NOTE: The head and cartridge must be mounted in the vertical position, with the cartridge hanging down.
3.Mount Filter Head Under Sink
A.Identify Dual Filter Head and Shut Off Valve (EV3098- 60).
B.Apply Teflon Tape to the threads on the inlet (left) side of the Head. Screw on the new Shut Off Valve and hand tighten. Repeat for the Stainless Coupler
C.Apply Teflon Tape to the threads of the Outlet Elbow Fitting (black band). Screw into the outlet of the Stainless Coupler. Wrap tape in direction of the threads to assure a tight fit and avoid small leaks.
D.Securely mount the filter head on the cabinet wall using the enclosed mounting screws and washers.
4.Go to page 2 and follow Basic Installation Instructions, Steps 4, 5, and 6, to complete the
2 |
22 " |
3 | Dual Filter Head | A | Shut Off Valve |
|
| ||
|
|
|
B |
C
D
Claims & NOTES
This installation must comply with all applicable state and local regulations.
Do no use with water that is microbiologically unsafe or unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on waters that may contain filterable cysts.
Testing was performed under standard laboratory conditions, actual performance may vary.
Systems Tested and Certified by NSF International against NSF/ANSI Standards 42 and 53 for the reduction of claims specified on the Performance Data Sheet.
• •