GE GXFM07HBL, GXFM07HWW Installing the System, Operation, External threads No

Installation Instructions

INSTALLING THE SYSTEM

1	Wash hands. Remove the
	existing aerator from the sink
	faucet. Do not discard gasket;	Gasket
	it may be necessary to use	Aerator
	the existing gasket for the
	installation of adapters.
	Identify the type of threads on
2
	the faucet:
	• External threads – No	Faucet
	adapters should be required.	adapters
	Proceed to Step 3.	and washers

•Internal threads – Select the proper adapter and washer combination from those provided. Screw adapter and gasket onto faucet.

Be careful not to cross-thread the adapter; tighten manually.

NOTE: Adapters and gaskets have been included to connect to most faucets. To insure a leak-free seal, you may need to use your existing gasket (removed during Step 1) from your faucet’s aerator in addition to the gasket included with this system. If the adapters

will not connect to your faucet, it is recommended to consult a local plumbing or hardware store for assistance in obtaining the correct adapter for your faucet.

3Connect the faucet mount filter to the faucet/adapter by turning the collar to tighten onto the threads of the faucet/adapter.

Be careful not to cross-thread the unit; tighten manually. It is not recommended but if necessary, you may use pliers to assist with installation. Be careful not to damage the swivel collar with the pliers.

Swivel collar

4Slowly turn on the cold water (about half open) and check for leaks. Tighten as necessary.

5With the cold water faucet fully open, rotate the

selector band to “Filtered Spray” or “Filtered Stream.” Flush new filter for 10 minutes to remove any harmless carbon fines that may

be in the system. The water will automatically

go back to “non-filtered water” when the cold water faucet is shut off.

3

OPERATION

After installing and flushing the filter system, fully open the cold water and rotate the selector band on the filter to

“Filtered Spray” or “Filtered Stream.” The selector band will automatically go back to the “non-filtered water” position; however, you will continue to receive filtered water until you turn the faucet off. You do not have to hold the cap to continue receiving filtered water. The green LED light will indicate the water pattern mode the system is in. Allow water to run for 3 seconds before use. When your water needs are finished, simply turn off the cold water. The water will automatically return to the non-filtered water mode when the water supply faucet is shut off.

FILTERED SPRAY

Turn the selector band to“Filtered Spray” when cleaning fruits and vegetables.

Green light

Selector band

Selector indicator

NOTE: You do not have to hold the cap to continue receiving filtered water.

FILTERED STREAM

Turn the selector band to “Filtered Stream” when you are filling a glass of water or using water for cooking.

Green light

Selector band

Selector indicator

NONFILTERED WATER

If you turn on the faucet but do not turn the selector band, you will receive unfiltered water through your faucet.

WARNING — Do not attempt to filter hot water above 100°F (37.7°C). It will damage the filter cartridge and decrease performance.

NOTE: If it is necessary to connect a portable dishwasher to your faucet, simply unscrew the filter from the faucet and attach the dishwasher according to the manufacturer’s instructions.