GE GXSF31E installation instructions Safety Precautions

Page 2

IMPORTANT SAFETY INFORMATION.

READ ALL INSTRUCTIONS BEFORE USING.

WARNING!

For your safety, the information in this manual must be followed to minimize the risk of electric shock, property damage or personal injury.

SAFETY PRECAUTIONS

Check and comply with your state and local codes. You must follow these guidelines.

Use care when handling the water softening system. Do not turn upside down, drop, drag or set on sharp protrusions.

Water softening systems using sodium chloride (salt) for recharge add sodium to the water.

Persons on sodium restricted diets should consider the added sodium as part of their overall intake. Potassium chloride can be used as an alternative to sodium chloride in your softener.

The water softening system works on 24 volt-60 Hz electrical power only. Be sure to use only the included transformer.

Transformer must be plugged into an indoor 120 volt, grounded outlet only.

Use clean water softening salts only, at least 99.5% pure. NUGGET, PELLET or coarse SOLAR salts are recommended. Do not use rock, block, granulated or ice cream making salts. They contain dirt and sediments, or mush and cake, and will create maintenance problems.

Keep the salt hole cover in place on the softener unless servicing the unit or refilling with salt.

WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

PROPER INSTALLATION

This water softening system must be properly installed and located in accordance with the Installation Instructions before it is used.

Install or store where it will not be exposed to temperatures below freezing or exposed to any type of weather. Water freezing in the system will break it. Do not attempt to treat water over 100°F.

Do not install in direct sunlight. Excessive sun or heat may cause distortion or other damage to non-metallic parts.

Properly ground to conform with all governing codes and ordinances.

Use only lead-free solder and flux for all sweat- solder connections, as required by state and federal codes.

The water softening system requires a minimum water flow of three gallons per minute at the inlet. Maximum allowable inlet water pressure is 125 psi. If daytime pressure is over 80 psi, nighttime pressure may exceed the maximum. Use a pressure reducing valve to reduce the flow if necessary.

Softener resins may degrade in the presence of chlorine above 1 ppm. If you have chlorine in excess of this amount, you may experience reduced life of the resin. In these conditions, you may wish to consider purchasing a GE point-of-entry household filtration system with a chlorine reducing filter.

WARNING: Discard all unused parts and packaging material after installation. Small parts remaining after the installation could be a choke hazard.

READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.

SAVE THESE INSTRUCTIONS

2

Image 2
Contents 7247182 215C1044P021 49-50083-104-02 JR Write the model and serial numbers here Model # Serial #Safety Precautions Unpacking and Inspection Installation instructionsImportant Installation Recommendations Tools and Materials Required for Installation Plan How You Will Install the SoftenerWhere to Install the Softener Typical Installation Illustration Optional 3-Valve Bypass Installation IllustrationMove the Softener Assembly Into Installation Position Step-by-step installation instructionsInstall Bypass Valve Plumb in and OUT Pipes to and from SoftenerInstall Grounding Clamp 4A. Connecting a Rigid Valve Drain TubeInstall the Brine Tank Overflow Fittings and Hose Connect to Electrical PowerSET Water Hardness Number Programming the ControlSET Present Time of DAY SET Recharge Starting TimeSYSTEM/ELECTRONIC Diagnostics Optional Control SettingsError Signals Salt EfficiencySanitizing Procedures Specifications/DimensionsAbout the water softener system Do not overtighten the cap Cleaning the Nozzle and Venturi AssemblyBreaking a Salt Bridge Feature/Service Automatic Electronic Diagnostics Feature Optional Recharge ControlsFeature Memory Normal Operation, Control DisplaysPossible Defect Service Electronic Demand Time Features and ServiceService Timer/Softener, Service Checkout Procedure Visual ChecksIf the code was changed, make ALL the timer settings Open a Nearby Soft Water FaucetIf the water softening system does not draw brine, check Checking the Salt Storage Level and Refilling Care and cleaning of the water softening systemCleaning Iron Out of the Water Softening System However, you must keep the tank supplied with saltThat does not mix soft and hard water Before you call for service…Problem Possible Causes What To Do No soft water Water feels slippery After installationNot using any salt Water softening systemBrown/yellow Brown/yellow colored Water after installationSalty tasting or Colored water Resin beads showingGEAppliances.com Parts list GEAppliances.com Parts catalog General Electric Parts CatalogSupport Screen Warrantor General Electric Company. Louisville, KY What Is Not CoveredFor The Period Of We Will Replace GE Water Softening System Warranty. For Customers in Canada For The Period We Will ReplacePage Información de seguridad Instrucciones para la Advertencia Advertencia No use con agua queDesempacado e inspección Instrucciones de instalaciónAdvertencia No use con Recomendaciones importantes para la instalaciónHerramientas y materiales necesarios para la instalación Planifique la instalación del DescalcificadorDónde instalar el Descalcificador Ilustración de instalación normal PrincipalInstrucciones de instalación paso por paso Instale LA Válvula DE BypassDE LA Válvula 4A. Cómo Conectar UN Tubo DE Drenaje DE Válvula RígidaConecte EL Suministro Eléctrico Instale LA Abrazadera DE TierraAgregue Agua Y SAL AL Tanque DE Salmuera Ajuste EL Nivel DE Dureza DEL Agua Programación del controlAjuste LA Hora DEL DÍA Ajuste LA Hora DE Inicio DE RecargaDiagnóstico ELECTRÓNICO/DEL Sistema Señales DE ErrorAjustes opcionales de control Eficiencia DE LA SALEspecificaciones/Dimensiones Procedimientos de desinfecciónSobre el sistema de descalcificación de agua Cómo romper un puente de sal Cómo limpiar la ensambladura de la boquilla y el Venturi Junta Tapón de flujoCaracterística/Servicio Diagnóstico electrónico automático Operación normal, Pantalla de controlFunción Memoria Recargue Esta NocheVisualizado Inspecciones VisualesServicio Diagnóstico electrónico iniciado manualmente Servicio Inspección manual del avance de la racarga Recharge recargoPrecaución No HAY Agua Descalcificada Problemas más comunes Antes de llamar para solicitar servicio…Que el problema haya sido corregido Está duraEl agua sabe a sal o tiene Notas Notas Notas Lista de partes GEAppliances.com Catálogo de partes Catálogo DE Partes DE General ElectricPASADOR, Expansión Lo que no está cubierto Garantía GE para el Sistema de Descalcificación de AguaPor el período de Reemplazamos Garante General Electric Company. Louisville, KYGarantías ampliadas Soporte al Consumidor Página Web de GE AppliancesSolicite una reparación Piezas y accesoriosConsumer Support GE Appliances Website Schedule ServiceParts and Accessories Real Life Design Studio

GXSF31E specifications

The GE GXSF31E is a state-of-the-art water filtration system that effectively addresses the need for clean and great-tasting water in residential applications. This model focuses on efficiency, reliability, and advanced filtration technologies that enhance water quality for everyday use.

One of the main features of the GE GXSF31E is its robust filtration capabilities. It utilizes a dual-stage filtration process that combines sediment filtration with activated carbon block technology. This dual approach not only removes common contaminants such as chlorine, sediment, and rust but also significantly improves the taste and odor of your water. As a result, users enjoy water that is not only safe but also refreshing and pleasant to drink.

In terms of capacity, the GE GXSF31E is designed to meet the needs of medium to large households. With a production capacity of up to 31,000 grains, it is capable of efficiently handling the water demands of families with multiple members. The system features a digital control panel that allows users to monitor and manage the filtration process effectively, providing alerts for filter replacements and ensuring optimal performance at all times.

The GE GXSF31E also incorporates advanced technologies for ease of maintenance. The unit is equipped with a self-cleaning mechanism that helps reduce the need for manual cleaning, thereby extending the lifespan of the filters and the system as a whole. This feature significantly enhances convenience, as homeowners can rely on the unit to maintain its efficiency without constant intervention.

Energy efficiency is another critical characteristic of the GE GXSF31E. The system is designed to operate with minimal energy consumption, making it an environmentally friendly choice for responsible consumers. Additionally, its compact design allows for easier installation and integration into limited spaces, which is particularly advantageous for urban settings.

The GE GXSF31E not only meets rigorous safety standards but also comes with a warranty that underscores its reliability and long-lasting performance. This product is ideal for families looking to improve their water quality with a dependable, efficient, and user-friendly filtration system that aligns with modern needs and environmental considerations.