Brother XE5427-001, 885-V51 operation manual Basic Steps for Embroidering

GETTING READY ————————————————————————————————————————————

Basic Steps for Embroidering

This section describes the preparations for embroidering.

The basic steps for embroidering are as follows.

1	Embroidery unit attachment	Attach the embroidery unit.
		For details, refer to "Attaching the embroidery unit" (page 19).
		↓
2	Needle preparation	Use a needle matched to the fabric.
		For details, refer to "Replacing the needle" (page 28).
		↓
3	Bobbin thread setup	For the bobbin thread, wind embroidery bobbin thread and set it in
		place.
		For details, refer to "Winding/Installing the Bobbin" (page 29).
		↓
4	Fabric preparation	Attach a stabilizer material to the fabric, and hoop it in an embroidery
		frame.
		For details, refer to "Preparing the Fabric" (page 43).
		↓
5	Embroidery frame	Attach the embroidery frame to the embroidery unit.
	attachment	For details, refer to "Attaching the Embroidery Frame" (page 47).
		↓
6	Pattern selection	Select an embroidery pattern.
		For details, refer to "Selecting Embroidery Patterns" (page 50).
		↓
7	Upper thread setup	Set up the upper thread according to the selected pattern.
		For details on setting up the thread, refer to "Upper Threading" (page 37).
		↓
8	Checking the layout	Check and adjust the size and position of the embroidery pattern.
		For details, refer to "Adjusting the layout and the size" (page 61).

16