Kenmore 625.34857 When to Refill with Salt, Please see page 9 for Salt Filling Directions

SECTION 3

I

3A. SALToooREFILLING STORAGE

WHEN TO REFILL WITH SALT

The Salt Monitor System (see page 10) will turn on the low salt light to warn you when to refill with salt. Check for a low salt light a few weeks after you install the softener, and evew week after that. Always ref'dl at about the #2 salt monitor level. At this level, the tank is about 1/3 full. Never let the softener use

CARE OF YOUR SOFTENER

I

TANK/BREAKING A SALT BRIDGE

all the salt before refilling. Without salt, you will soon have hard water.

NOTE:

You will have a loss in softening capacity and may get partly hard water if less than 10 inches (salt monitor level 2) of salt is in the storage tank.

PLEASE SEE PAGE 9 FOR SALT FILLING DIRECTIONS.

BE SURE TO RESET THE SALT MONITOR, PAGE 10.

SALT BRIDGE

SALT BRIDGE

Sometimes, a hard crust or salt bridge forms in the salt storage tank. It is usually caused by high humidity or the wrong kind of salt. When the salt bridges, an empty space forms between the water and salt. Then salt will not dissolve (melt) in the water to make brine. Without brine, the resin bed does not regenerate and you will have hard water.

If the storage tank is full of salt, it is hard to tell if you have a salt bridge. Salt is loose on top, but the bridge is under it. The following is the best way to check for a salt bridge.

Salt should be loose all the way to the bottom of the tank. Hold a broom handle, or like tool, up to the softener as shown in FIG. 9. Make a pencil mark on the handle, 1." or 2" below the top height of the rim. Then, carefully push it straight down into the salt. If a hard object is felt before the pencil mark gets to the top of the tank, it's most likely a salt bridge. Carefully push into the bridge in a few places to break it. Do

not try to break the salt bridge by pounding on

the outside of the salt tank. You may damage it.

If the wrong kind of salt made the bridge, take it out. Then fill the tank with nugget or pellet salt only.

push tool into salt bridge to break

Pencil

Mark

Broom Handle

Salt

Salt Bridge

Water Level

15