Chapter 2 Setting Up Your Cisco Unified Videoconferencing 3500 Gateway
Physical Description
Table | Front Panel Components | |
|
|
|
Component |
| Description |
|
| |
10/100 BaseT connector | An | |
|
| network port. |
|
| |
SERIAL connector | A | |
|
| configuration. |
|
|
|
RST button |
| Allows you to reset the Cisco Unified Videoconferencing 3500 Gateway unit |
|
| manually. |
|
|
|
GK Reg LED |
| Lights green when the Cisco Unified Videoconferencing 3500 Gateway unit |
|
| is registered with a gatekeeper. |
|
|
|
CD LED |
| Lights green when a PRI or BRI line is enabled and a carrier signal is |
|
| detected |
|
|
|
ACT LED |
| Lights green to indicate that there are active calls in the Cisco Unified |
|
| Videoconferencing 3500 Gateway unit. |
|
|
|
ALARM LED |
| Lights green to indicate that an error has occurred and the Cisco Unified |
|
| Videoconferencing 3500 Gateway unit requires resetting. |
|
| |
10/100 BaseT LEDs | The top part of the 10/100 BaseT connector contains two LED indicators. | |
|
| The |
|
| |
|
| when the connection speed is 10 Mbps. |
|
|
|
Cisco Unified Videoconferencing 3527 PRI Gateway Rear Panel
Figure 2-2 shows the rear panel components of the Cisco Unified Videoconferencing 3527 PRI Gateway unit. Table 2-2 describes these components.
Figure 2-2 Cisco Unified Videoconferencing 3527 PRI Gateway: Rear Panel
ACT | ACT |
ALARM | ALARM |
Table
157266
Component | Description |
|
|
ACT LED | Lights green to indicate that there are active calls in the gateway. |
|
|
Lights green to indicate that the PRI line is enabled and a carrier signal is | |
| detected. |
|
|
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3522 BRI Gateway and 3527 PRI Gateway Release 5.5
|
| |
|