Chapter 2 Setting Up Your Cisco Unified Videoconferencing 3500 Gateway
Preparing for Installation of the Cisco Cisco Unified Videoconferencing 3527 PRI Gateway
Table
Component | Description |
ALARM LED | Displays alarm events for the PRI line. |
•YELLOW
•
PRI LINE connector | |
| PRI port. |
Cisco Unified Videoconferencing 3522 BRI Gateway RTM
Figure 2-3 shows the rear panel components of the Cisco Unified Videoconferencing 3522 BRI Gateway unit. Table 2-3 describes these components.
Figure 2-3 Cisco Unified Videoconferencing 3522 BRI Gateway: Rear Panel
|
|
| 1 | 2 |
|
|
| 3 | 4 |
ACT |
157262
Table
Component | Description |
|
|
ACT LEDs | Lights green to indicate that there are active calls in the gateway on the |
| specified BRI line. |
|
|
BRI LINE connectors | |
| gateway ISDN BRI port. |
|
|
Preparing for Installation of the Cisco Cisco Unified Videoconferencing 3527 PRI Gateway
This section describes the requirements for installing the Cisco Unified
Videoconferencing 3527 PRI Gateway unit.
•Proper clearance at the sides of the unit to allow adequate ventilation, and at least 20 cm clearance at the back of the unit to allow access to cable connections
•A PC with a serial port and terminal emulation software to assign the Cisco Unified Videoconferencing 3527 PRI Gateway unit an IP address
•Dedicated IP address for the Cisco Unified Videoconferencing 3527 PRI Gateway unit
•The IP address of the router that the Cisco Unified Videoconferencing 3527 PRI Gateway unit will use to communicate across the network
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3522 BRI Gateway and 3527 PRI Gateway Release 5.5
|
| ||
|
|