Frigidaire 819042236-01, EA108T installation instructions Rm rmoa, Block, Tapered spacer

INSTALLATION

8.If you wish to keep the unit beoperatedathigher

performance state, remove the steel rear grille and

attach the plastic rear grille. The plastic grille will

minimize the recirculation of hot discharge air.

Plastic rear grille

Steel rear grille

Fig. F

9.If thedepth ofyour existingwall sleeve is less than or equal to 20", skip to step 11. Otherwise, cut the

baffles and the support blocksaccording to length"A" in thetable below.

Depth	"D"of	the
existing	wall		Length "A"
sleeve	(inches)		(inches)
20<D_<20%
20%<D..<2		I_	I-_
213/4<D_<24			4

11.lnstallthe new unit intothe wall sleeve.

12.To assemble trim, snapthe tab ofeach piece into the slot of the other piece asshown below. Remove

the backing from the trim foamand stick thattothe inside of the trim as shown below.

HorizontalVertical

rm rmoa

Assemble Trim Attach Trim Foam

Fig. 1

12.Slide trim over thefront ofthe airconditioner until trim is flush with sleeve as shown below.

Fig. J

NOTE: Be sure to route the cord through the trim frame before placing the trim frameon the unit.

10.Remove the backing from the support blocks and attach them to the inside of the wall sleeve as shown

FIG 14. Slide the baffle intoslotsofthesupport blocks.

I	/"	....................................	"	7	"
Wall __			i_i' i		BPerc_dBtPaaSer
Sleeve	"	_	""'_"i" _
W__			.-/'/	_	Block
				'----	_-Tapered spacer

Fig. H

•Air conditioners covered in this manual pose an excessive weight hazard. Two or more people arc needed to moveand install theunit. To prevent injur_

orstrain, useproperlifting and carrying technique, _

when moving unit.

•When handling the air conditioner, be carefult(

avoid cuts from sharp metal fins onfrontand rear coils.

•Make sure air conditioner does not fall durin( removal.