Kompernass SFW 250 A1 manual Assembly / Disassembly, To avoid the risk of accidents and injuries

Page 5

To avoid the risk of accidents and injuries:

Never put your hand into the openings of the ap- pliance. Do not insert any objects of any kind into the openings – except for the appropriate stodger and the foodstuff to be processed. If you do, there will be a serious risk of accidents!

Unplug the appliance from the power source be- fore attaching or removing accessories.

Do not leave the appliance unsupervised when it is ready for use. To avoid it being switched on accidentally, always unplug the appliance after use or during breaks.

Use only original accessories for this appliance. Other accessories may not meet the safety requirements.

This appliance is not intended for use by individuals (including children) with restricted physical, physio-lo- gical or intellectual abilities or deficiences in experience and/or knowledge unless they are supervised by a person responsible for their safety or receive from this person instruction in how the appliance is to be used.

Children should be supervised to ensure that they do not play with the appliance.

Never operate the appliance in a no-load condi- tion. This could irreparably damage the appliance.

5. Assembly / Disassembly

IMPORTANT: All accessories are coated with a thin film of oil to protect them from corrosion. Therefore carefully clean all of the parts before using the appliance for the first time, as com- prehensively described on chapter "8 Clea- ning". After subsequent usage, always apply a light coating of cooking oil to the metallic components.

a) Assembling the meat grinder

Unfold the fold-out side. There you will find the step-by-step illustrations for assembling the appliance.

Place the transport screw y into the mincer casing t.

Place the spring u onto the transport screw y.

Then place on the cross blade i so that the sharp side points away from the spring u.

Caution:

The cross blade i is very sharp! Risk of injury!

Important!:

The appliance will be damaged if the cross blade i is inserted the other way around!

Select the desired cutting disc. The cutting discs that are not required can be stored in the small

compartment on the appliance (Fig. ).

To open it, press on the symbol on the cover. The cover can now be opened. Insert the two unrequired cutting discs.

Insert the selected cutting disc o into the meat grinder casing t, so that the indentations on the cutting disc o lie on the fixing points in the meat grinder casing t.

When everything has been correctly assembled, screw the ring clamp a on until it is handtight.

- 3 -

Image 5
Contents Mincer SFW 250 A1 SFW 250 A1 Content Safety Instructions Technical dataItems supplied Intended useTo avoid the risk of accidents and injuries Assembly / DisassemblyAssembling the meat grinder Cross blade i is very sharp! Risk of injuryAssembling the kubbe attachment Assembling the sausage attachmentAssembling the biscuit pastry attachments Remove the meat grinder casing t as described under aProcessing meat OperationOperating the appliance Processing sausage meat Using the kubbe attachmentTip Making biscuit pastryCleaning the motor block Troubleshooting CleaningCleaning the accessories When the drive runs smoothly again, release the REV buttonStorage Warranty and serviceDisposal Store the appliance in a dry placeKubbe Importer RecipesBiscuits Fresh Grill SausagesGrill the sausages well and eat them on the same day Lay the biscuits on a baking tray lined with baking paper