Kompernass KH 1602 Operating Elements, Taking it into use, Handling the grill, Take note

•Avoid heat accumulation. Do not lay aluminium foil or other grilling utensils on the grill bars. An accumulation of heat could destroy plastic parts as well as the non-stick coating.

•Use the Table grill KH 1602 exclusively with the supplied thermostat.

•Take the grill plate into use ONLY when it is lying on the catchment pan.

•Detach the power plug and cable from the appliance when it is not in use, when you detach parts or before cleaning the appliance.

Operating Elements

q Grill bars

w Splatter protection shield

e Connection for power cable with thermostat r Catchment pan

t Heat-insulated handles y Heating element

u Indicator lamp

iThermostat

Taking it into use

Before taking the table grill into use for the first time clean it as described in the chapter “Cleaning and care”.

Usage / grilling may only take place with the catch- ment pan r intended for the purpose.

The voltage of the power source must tally with the details given on the rating plate of the appliance.

Handling the grill

A good and even heat distribution is assured by the integrated heating element y in the grill plate. Cleaning is made easier by the non-stick coating, which prevents the adhesion of grillables.

•Fill the collecting pan r with a maximum of 0.5 l of water. You can thus prevent the burning-on of fats falling from the grillables and make the sub- sequent cleaning of the appliance easier.

•Install the splatter protection shield w at the rear of the grill bars should you be grilling greasy grillables. Additionally, it serves well as a wind- break if being used outdoors: Insert the three tenons of the splatter protection shield w into the holes provided on one side of the grill bars q. To do this, the splatter protection shield w must be lightly flexed.

•Place the grill on an absolutely level and even surface.

•Place the grill on a base material that is not sensitive to heat.

•Check to ensure that the grill bars q are correctly placed onto the catchment pan r (see Fig. ￿).

•First insert the power cable with thermostat i into the appliance and then connect it to the power source.

•Adjust the thermostat i to the desired tempera- ture setting.The grill starts to warm up and the indicator lamp u glows.

•As soon as the indicator lamp u goes out the grill has reached the adjusted temperature and is ready for use.

Take note

Subject to the ambient temperature, it can occur that the control lamp u does not extinguish on thermo- stat setting "M".

•The grill is ready for use after a heating-up pha- se of ca. 15 minutes.

- 3 -