Operating Elements | Boiling water | |
|
|
|
1Unlocking button 2 On/Off switch 3 Base
4 Scale with integrated control lamps
5 Pourer sieve
Commissioning
Caution
Always and only use fresh tap water in the water boiler! Do NOT consume water that is not specifi- cally designated as drinking water. If you do, there will be a risk of damage to your health!
• Before taking the appliance into use, ensure that ...
-the appliance, the plug and the power cable are in good working order and...
–all packaging materials have been removed from the device.
•Fill the appliance with water up to the MAX marking and let it come to a full boil once – as described in the next section.
•After it has boiled, pour this water away.
•Rinse the water boiler out with clear water.
•Fill the appliance with water up to the MAX marking on the scale 4 and then bring it to the boil. When done, pour this water away also.
The appliance is now ready for use.
Danger
Never place the electrical base 3 in close proximity to water – a potentially fatal risk!
Notice
Always use fresh tap water. Do not consume any water that has already stood in the water boiler for longer than one hour. Do not reboil water that has cooled down. Always pour old water away. Microbes could have formed in it!
•Lift the kettle off of the base when filling it!
•Open the lid by drawing the unlocking button 1 to the rear and, at the same time, lifting the lid up.
•Hold the kettle upright while filling it. Only in this
way can you correctly read the markings
on the scale 4. Fill the kettle...
–at least to the MIN mark, so that the device does not overheat,
–no higher than the MAX mark, so that no boiling water spills out.
•First close the lid and then place the kettle onto the base 3, ensuring that it is is firmly seated on the base 3.
•Now insert the plug into the mains power socket.
•Press the ON/OFF switch 2down until it engages downwards.
•The control lamps integrated into the scale 4 now indicates that the appliance is heating up.
•The appliance switches itself off, and the control lamps goes out as soon as the water is on the boil. The ON/OFF switch 2 is released upwards.
- 2 -