Kompernass KH 1028 Cleaning and Care, Storage, Injury hazard, Risk of personal injuries

￿Warning

First remove the plug from the wall power socket before you lift the kettle from the base 3. This avoids the risk that any water splashing out could come into contact with live electrical connections in the base 3, which could cause a short circuit.

￿Injury hazard

For safety reasons, the lid should not be opened while the water is boiling or is very hot.

There is a risk of receiving severe scalds.

Cleaning and Care

￿Danger

Do not open any part of the housing.

There are no user-servicable elements inside. An open housing can create the risk of a lethal electrical shock.

Never submerse any parts of the appliance in water or other liquids! This can create the risk of a life-threatening electrical shock if residual liquid comes into contact with powered components.

￿Risk of personal injuries

Before cleaning the appliance, remove the plug from the mains power socket and allow the appliance to cool down.

•Clean the exterior surfaces and the power cord with a slighly damp cloth. Be sure to dry the appliance well before taking it back into use.

•For stainless steel surfaces, you can use appropriate cleaning agents from a specialized dealer.

•Never use detergents, abrasive cleaners or solvents. These can damage the appliance.

In the event of scale deposits:

•Before descaling, remove the pourer sieve 5 (see chapter "Removing/replacing the pourer sieve").

•Obtain any decalcifying agent suitable for kitchen utensils (e.g. decalcifiers for coffee machines) from a hardware shop. Proceed as detailed in the instructions provided for the use of the decalcfying agent.

Removing/replacing the pouring sieve

•Open the lid.

•Using the finger depression of the pourer-sieve 5, draw the pourer sieve 5 forwards and, at the same time, upwards.

•Remove the pourer sieve 5.

•Clean the pouring sieve 5with a lightly moistened dishcloth and under running water.

•After cleaning it, replace the pourer sieve 5. Ensure that the clasp at the lower end of the pourer sieve 5 wraps itself around the peg in the water boiler. Press the pourer sieve 5 downwards until it is firmly seated.

Notice

Should the scale deposits in the pourer sieve 5 be firmly established, lay it in a water-vinegar solution having a ratio of 6:1 for a few hours. The scale deposits will dissolve themselves. Rinse the pourer sieve 5 with lots of clear water.

Storage

Allow the appliance to cool off completely before putting it into storage.

•Wind the power cable around the cable retainer on the underside of the base 3.

•Store the appliance in a dry place.

- 3 -