Directed Electronics Rear Panel Connections, D600 uses 1-40A fuse, the D800 uses 2-25A fuses

REAR PANEL CONNECTIONS

1.Fuses - These fuses protect the amplifier against internal electrical damage and are meant to protect the amplifier only. All other power connections should be fused at the source.

The D600 uses 1-40A fuse, the D800 uses 2-25A fuses.

2.(+) 12 Volt Power - Connect this terminal through a FUSE or CIRCUIT BREAKER to the positive terminal of the vehicle battery or the positive terminal of an isolated audio system battery.

WARNING: Always protect this power wire by installing a fuse or circuit breaker of the appropriate size within 12 inches of the battery terminal connection.

2.Remote Turn On - This terminal turns on the amplifier when (+) 12 volt is applied to it. Connect it to the remote turn on lead of the head unit or signal source.

2.Ground - Connect this terminal directly to the sheet metal chassis of the vehicle, using the shortest wire necessary to make this connection. Always use wire of the same gauge or larger than the (+) 12 volt power wire. The chassis connection point should be scraped free of paint and dirt. Use only quality crimped and/or soldered connectors at both ends of this wire. DO NOT connect this terminal directly to the vehicle battery ground terminal or any other factory ground points.

3.Speaker Terminals - Connect subwoofers to these terminals. (Refer to the Speaker Wiring Diagrams section of this guide.)

8 © 2005 Directed Electronics, Inc. all rights reserved