Electrolux AT 143 E, AT 143 U operating instructions Installation, Connecting to the mains

Page 11

UK

Installation

1.Remove any promotion label from the door.

2.Install the oven on a flat, level surface. The surface must be strong enough to safely bear the weight (15 kg) of the oven, and the contents. To avoid the possibility of causing vibration or noise the oven must be in a stable position.

3.Keep the microwave oven away from sources of water and extreme heat, e.g. radiators and boilers. This appliance should not be installed next to a radiator or boiler as this can lead to the appliance malfunctioning

4.Do not block air vents on the top and the sides of the cabinet and also do not place any articles on the top of the oven. If air vents are blocked during operation, the oven may overheat, and this may lead to malfunctioning. Hot air escapes from the vents, so be sure not to obstruct it or let curtains come between the oven and the rear wall.

5.Place the oven as far away from radios and TV’s as possible. This oven does conform to EEC requirements* of radio interference suppression, but some interference may occur if it is placed too close to a radio or TV, so keep them as far apart as possible.

This appliance conforms to the requirements of EEC Radio Interference Directive 87/308/EEC.

Connecting to the mains

The oven is delivered with the power cord and a plug for 230 –240 V, 50Hz, earthed socket outlet.

Earth protection minimizes the risks should a short circuit occur. Check to ensure the voltage of the oven matches the supply.

N.B. If the oven is connected to the socket via an extension cord, make sure the cord is earthed.

1WARNING! This appliance must not be used on a non earth protected power supply.

Contact an electrician if you are uncertain regarding electrical connection of the oven or provision of earth protection of the supply.

This appliance must be earthed. If this appliance is fitted with a non- rewirable plug for which your socket is unsuitable, the plug should be cut off and the appropriate plug fitted. If it is necessary to change the fuse in a nonrewirable plug, the fuse cover must be refitted. If the fuse cover is lost or damaged, the plug must not be used until a replacement is obtained. These are available from your local AEG Service Force Centre.

11

Image 11
Contents Micromat 143 E/U Dear customer Contents Disposal of old appliances Important informationPackaging materials For trouble free and safe operation Safety instructionsGeneral Microwaves Do not use your microwave oven for the following Suitable ovenware Ovenware material Mode of operation General operating instructions Table top model Installing and ConnectingDouble the quantity/weight = nearly * double the time What else to noteBuilt-under model Built-in modelConnecting to the mains Installation∙ WARNING! this Appliance Must be Earthed Electrical connectionsAppliance Product DescriptionMulti function button to set Control panelAccessories Example 1215 hrs Before using the applianceSetting the clock Press the START-button «At a glance» operating instructionsPress door release button ∙ Press Multi function button Press the Clear button ‘ STOP’Example 1 minute 15 seconds on microwave output level 750 W SettingModes of operation Page Automatic defrost Automatic ProgrammesFor frozen vegetables Automatic cooking programmesFor fresh vegetables I+II Press the Start button How to use automatic programmesExample defrosting 1 kg chicken START-button How to setQUICK-Start Minute timer with alarm Defrosting Cooking charts and tipsHeating of refrigerated food and drink BreadPastry Melting of foodDrinks Cooking charts and tipsCooking vegetables Cooking fishCooking Practical tips for useCooking of meat and poultry GeneralReady made meals Tips on microwavingDefrosting of fruit and vegetables IEC Test proceduresPart Turntable and Turntable support Cleaning and careAppliance Exterior Cooking areaMicrowave appliance is not working properly ? Check that What to do if08705 929 Service and Spare PartsCustomer Service Guarantee Conditions Guarantee Conditions