Install Filters, NON-DUCTED Hoods only

INSTALL FILTERS

(DUCTED AND NON-DUCTED HOODS)

1.To remove the GREASE filter, push in on the metal latch tab and tilt filter downward to remove.

2.To install the GREASE filter, align rear filter tabs with slots in the hood. Depress the metal latch tab, push filter into position and release. Make sure filter is securely engaged after installation.

NOTE: Prior to use, remove protective film from the filter frame.

(NON-DUCTED HOODS ONLY)

1.To remove the NON-DUCTED RECIRCULATION filter, push-in on the front filter latch. Pull the filter down to disengage the rear filter tabs. Fig. 17.

2.To install the NON-DUCTED RECIRCULATION filter, align the rear filter tabs with slots in the hood. Push the filter up into place until the front latch snaps securely into its slot. Make sure the filter is securely engaged after assembly.

3.Install GREASE filters after Non-ducted Recirculation filter is installed.

GREASE FILTERS

FIG.16

NON-DUCTED

RECIRCULATION

FILTER

FIG.17

- 10 -