Electrolux 7388KG Temperature Operation Operation Controls, Refrigerator Controls, Important Tips

Temperature

Operation Operation Controls

Before starting the refrigerator, follow these important steps:

•Insert the power cord into a properly grounded electrical receptacle. DO NOT use an extension cord or an adaptor.

•If your refrigerator is equipped with an automatic ice maker, see section “AUTO- MATIC ICE MAKER” for starting procedure.

•Set the controls at midpoint at start up. See section “TEMPERATURE CONTROLS” if adjustments are desired.

•To ensure safe food storage, allow the refrigerator to operate with doors closed for at least 8 hours before loading with food.

•To maintain temperatures, a fan circulates air in the refrigerator and freezer compart- ments. Do not block air vents with food items.

When taking the refrigerator out of service for a period of time:

•Remove all food and ice. Turn the controls to the “O” position and disconnect the service cord.

•If equipped with an ice maker, raise the signal arm to its locked position (see Figure 1) and turn off the water supply at its valve.

NOTE: When placing the refrigerator back into service, leave ice maker off until water supply is turned on.

•Clean the interior thoroughly.

•Leave both doors open to prevent odor and mold build-up.

REFRIGERATOR CONTROLS

The refrigerator controls should be set at midpoint of the dial for a period of 24 hours. After 24 hours, adjust the control if needed. To obtain a COLDER temperature, turn the knob clockwise to a higher number. To obtain a WARMER temperature, turn the knob counterclockwise to a lower number. Note that storage temperatures may be affected by room temperature.

FREEZER CONTROLS

The freezer controls are located inside the freezer compartment. The freezer should be set at midpoint for a period of 24 hours. After 24 hours, adjust the control if needed.To obtain a COLDER temperature, turn the knob clockwise to a higher number. To obtain a WARMER temperature, turn the knob counterclockwise to a lower number.

IMPORTANT TIPS

•Turning the freezer control to “0” will shut down cooling in BOTH the refrigerator and the freezer compart- ments.

•When first setting the controls or when changing a setting, wait 24 hours for the temperature to stabilize before making more changes.

•A change in the control setting in the freezer compartment will affect the temperature in BOTH the freezer and the refrigerator compartment.

Figure 1	On
	Encendido
Figura 1
	Marche
Figure 1
	Ein
Abbildung 1
	Áíïéêôü
Ó÷Þìá 1

1 Ἆ		áø²¥šZ	Ú•z
			Off
		Apagado
	Wire Signal Arm		Arrêt
	Señal de Alarma		Aus
	Bras de coupure		Êëåéóôü
	Signalhebel	v£¹–îZ Ú•z

Âñá÷ßïíáòÓÞìáôïò

f£ŽîZ oZfe

5