6Control panel
8Freezer compartment indicator
9FROSTMATIC indicator
10FROSTMATIC button
11Freezer temperature regulator, + button
12Freezer temperature indicator
13Freezer temperature regulator, - button
14Alarm reset button
15Alarm indicator
Switching on
1.Insert the plug into the mains socket.
2.Set ON/OFF switch to ON.
3.The alarm indicator light flashes since the temperature is reached. The acoustic alarm sounds.
4.Press the alarm reset button to reset the alarm.
Switching off
To switch the entire appliance off:
1.Set ON/OFF switch to OFF.
2.Disconnect the mains plug from the mains socket.
Temperature indicators
The temperature indicators show several information:
•During normal operation, the temperature currently present in the fridge (ACTUAL tem- perature) is displayed.
•In the freezer the warmest temperature is displayed (ACTUAL temperature). When fully filled, the warmest zone is normally located at the top in the front area of the freezer. Depending upon how the section is filled, the temperatures are lower in other areas of the freezer.
•When the temperature is being adjusted a flashing display indicates the fridge temper-
ature currently set (DESIRED temperature).
When changing the temperature setting wait about 24 hours until the temperature display has stabilised.
If there is a fault in the appliance the temperature indicator shows:
•a square or a letter in the temperature indicator of the fridge for a fault in the fridge
•a square or a letter in the temperature indicator of the freezer for a fault in the freezer.
Temperature regulation
To operate the appliance, proceed as follows:
1.Set the required temperature by pressing the corresponding temperature regulator. The temperature indicator will immediately show the changed setting (DESIRED tempera- ture) and the temperature indicator flashes.
2.Each time the temperature regulator is pressed the DESIRED temperature is adjusted by 1 °C. The DESIRED temperature must be reached within 24 hours.
3.Once the required temperature has been set, after a short period (approx. 5 sec.) the temperature indicator will show again the current ACTUAL temperature inside the cor-