Electrolux FKCH17F7HW Compressor Area Components, Power Cord Removal, Filter-Drier Removal

Page 43

Component Teardown

Compressor Area Components

Power Cord Removal

The power cord enters the compressor area on the lower left side and is secured to the compressor mounting plate with a P-clamp and screw.

To remove the power cord:

1.Pull unit from its installation position to access the rear compressor area.

2.Using a phillips head screwdriver, extract the four screws securing the compressor area shield to the rear of the unit. Remove shield.

3.Using a 1/4” socket or wrench, extract the screw securing the P-clamp to the compressor mounting plate. (See Figure 5-23)

4.Using a 1/4” socket or wrench, extract the screw securing the ground wires to the compressor mounting plate.

5.Disconnect power cord from the wire harness at the quick disconnect. Remove power cord from unit.

Filter-Drier Removal

The filter-drier is located in the compressor area on the left side of the compressor. (See Figure 5-24)

To remove the filter-drier:

1.Pull unit from its installation position.

2.Extract the screws securing the fiber board cover to the unit frame and remove from unit.

3.Recover refrigerant by using EPA approved recovery system.

4.Using a 3 cornered file, score a groove around capillary tube as close to old filter-drier as possible. Break capillary tube along score mark from filter-drier.

5.Cut condenser outlet tube at filter-drier. Discard filter-drier.

6.Thoroughly clean condenser outlet tube and capillary tube.

7.Place inlet connection of filter-drier over condenser tube approximately ¼” and solder.

8.Insert capillary tube input end into filter-drier outlet. Do not allow tube to bottom against screen. Solder carefully so that solder does not plug capillary tube.

9.Install process tube adapter to filter-drier.

10.Evacuate and charge system using the recommended procedure described under Evacuating and Recharging in the Refrigeration section.

11.Reassemble unit.

Electrical

Connection

Ground

Screw

P-Clamp

and Screw

Figure 5-23. Power Cord Removal

Cut Here

Cut Here

Figure 5-24. Filter-Drier Removal

On R-134a systems, the system must NOT be left open to the atmosphere for more than 10 minutes to prevent moisture contamination of compressor oil.

4-11

Page 42 Page 44
Image 43
Page 42 Page 44
Contents Convertible Refrigerator / Freezer Page Basic Information SectionElectronic Control Safe Servicing Practices Installation InformationProduct Features Crisper Adjustable ShelvingDoor Storage Crisper DrawersSerial Plate Care and CleaningCleaning The Inside Cleaning The OutsideElectronic Control Switching Between Refrigerator and Freezer Mode Electronic Temperature ControlSetting Selection Fan Relay Operation of Electrical Control ComponentsFreezer and Refrigerator Modules Ambient ThermostatService Diagnostic Mode Stuck Key Error IndicationFail Safe Mode Exiting Fail Safe ModeElectronic Control Refrigeration System Definitions Safety WarningsRefrigerant Cycle Basic ComponentsCompressor Replacement Testing for Refrigerant LeaksLow/High Side Leak or Undercharge Do not exceed 150 Psig To Flush The SystemTo Use Refrigerant To Flush The System Do not exceed 300 PsigDo not use compressor if you do not hear this sound Installing a New CompressorCondenser Replacement Evaporator and Suction Line Replacement Filter-Drier InstallationEquipment Needed for Evacuation & Recharging Installing Evacuation and Recharging EquipmentCharging The System Evacuating SystemFinal Leak Test Miscibility of R-134a and Ester Oil Verify Refrigerant Type In The SystemDedicated Equipment 134a Refrigeration SystemsWater In The Refrigeration System Refrigerant Leaks Vacuum Pump Maintenance134a properties Leak DetectionHFC-134a, CFC-12 Pressure Temperature Chart Skin and Eye Contact Inhalation ToxicityCardiac Sensitization Spills or LeaksBulk Delivery and Storage Leak TestingRefrigerant Recovery Systems Combustibility of HFC-134aComponent Teardown Component Teardown Kickplate Removal Door Hinge and Door Assembly RemovalExterior Components Door Handle RemovalDoor Gasket and Inner Panel Removal Door Stop RemovalTwo Liter Door Bin Removal Gallon Door Bin RemovalCrisper Drawer Removal Door Switch RemovalGlass Shelf Assembly Removal Interior ComponentsLight Shield Removal Crisper Cover Assembly RemovalLight Fixture Removal Baffle Plate Removal Control Switch RemovalEvaporator Cover Removal Electronic Control Removal 19. Evaporator Fan Assembly RemovalDefrost Heater Removal Defrost Thermostat RemovalEvaporator Removal Compressor Area Components Power Cord RemovalFilter-Drier Removal 25. Compressor Electrical Component Removal Compressor Removal27. Drain Pan Heater Loop Removal Drain Pan and Drain Pan Heater Loop RemovalCondenser Service Troubleshooting Problem Cause Correction Troubleshooting Compressor and evapora- tor fan motor does not run Troubleshooting Troubleshooting Wiring Diagrams Wiring Diagrams Wiring Diagrams Installation Information Safety Precautions Important Safety InstructionsInstallation Information Leveling LocationTo Level Unit Electrical Receptacle Electrical InformationDoor Handle Mounting Instructions Door RemovalModel FKCH17F7HW Unit Dimensions Installation Information

FKCH17F7HW specifications

The Electrolux FKCH17F7HW is a standout refrigerator designed to meet the needs of modern households. With its sleek design and advanced features, it not only enhances the kitchen aesthetic but also promotes efficient food storage and preservation.

One of the key features of the FKCH17F7HW is its spacious interior. The refrigerator offers a generous capacity, making it ideal for families or individuals who like to stock up on groceries. Its flexible shelving system allows users to adjust the heights of shelves, accommodating very tall items and optimizing storage space.

The FKCH17F7HW comes equipped with advanced cooling technologies that ensure consistent temperature control. The Frost Free technology prevents the buildup of ice, saving users from the hassle of manual defrosting. This feature also allows for more efficient cooling, which in turn reduces energy consumption. The dynamic cooling system circulates air evenly throughout the refrigerator, helping to maintain an ideal temperature for perishable foods.

Another noteworthy characteristic is the humidity-controlled crisper drawers. These drawers provide an optimal environment for fruits and vegetables, keeping them fresher for longer. By regulating humidity levels, the crisper drawers also help to prevent spoilage, which not only saves money but contributes to less food waste.

In addition to storage practicality, the FKCH17F7HW incorporates energy-efficient technologies. The appliance is designed with an A+ energy rating, which means it operates with lower energy consumption without sacrificing performance. This eco-friendly feature not only benefits the environment but also reduces electricity bills.

The refrigerator also boasts user-friendly controls. Its intuitive electronic control panel makes it easy to adjust settings and ensure optimal performance. Moreover, the LED lighting illuminates the interior, making it easy to find what you need, even in low light conditions.

In summary, the Electrolux FKCH17F7HW is a remarkable refrigerator that combines style, functionality, and energy efficiency. With its generous capacity, advanced cooling technologies, and user-friendly features, it stands as a reliable appliance for any kitchen. Whether you're looking to preserve fresh produce or store family meals, this refrigerator meets a wide range of storage needs while maintaining an attractive design.
Top Page Image Contents