Dolby Laboratories HT2030 Listening to the Radio, To turn off the radio, To improve reception

To tune in a station with a weak signal

Press TUNING (v/V) repeatedly in step 3 to tune in the station manually.

To clear all memorized stations

Press and hold MEMORY until “MEM CLEAR” appears on the front panel display. Then press MEMORY again to clear all stations.

ote

If all 30 stations have already been entered, MEM FULL will appear on the front panel display for a moment and then a preset number will flash. To change the preset number, follow steps 5-6 as above.

Press MEMORY.

A preset number will flash on the front panel display.

Press TUNING (v/V) on the front panel to select the desired preset number.

Press MEMORY again. The station is stored.

Repeat steps 3-6 to store other stations.

4

5

6

7

Scanning stops when the DVD Receiver tunes in a station. “STEREO” (for stereo program) appears on the front panel display.

information appears on the TV screen.

2 Press RADIO repeatedly to toggle between AM and FM.

3 Press and hold TUNING (v/V) on the front panel until the frequency indication starts to change, then release.

FM or AM appears on the front panel display and radio

Press RADIO.

1

Press PRESET (v/V) repeatedly to select the desired preset station.

FM or AM appears on the front panel display and radio information appears on the TV screen. The last received station is tuned in.

Press RADIO.

Radio Operation Presetting Radio Stations

You can preset up to 30 FM and AM stations. Before tuning, make sure you have turned down the volume to the minimum level.

Listening to the Radio

Before you begin, be sure to preset your favorite radio stations in the DVD+VCR’s memory (see “Presetting radio stations” at left).

1

2

3 Adjust the volume by rotating the VOLUME knob on the front panel or by pressing VOLUME +/- on the remote control repeatedly.

To turn off the radio:

Press POWER to turn the DVD+VCR off or select another function mode (DVD, VCR, or AUX).

To listen to non-preset radio stations:

For manual tuning, press TUNING (v/V) on the front panel repeatedly.

For automatic tuning, press and hold TUNING (v/V) for about two seconds on the front panel.

For your reference

If an FM program is noisy

Press AUDIO so that “STEREO” disappears from the front panel display. There will be no stereo effect, but the reception will improve. Press the AUDIO button again to restore the stereo effect.

To improve reception

Realign the antenna.

37

OPERATION