Mounting of hood
lFit the drilling scheme onto the wall at the right
height. (Fig. 4)
The lower edge of the scheme correspond to the lower edge of the cooker hood.
lOn the drilling scheme is printed a line corre- sponding to the centre of the appliance; with a pencil draw a line up to the ceiling, this will aid installation procedures. (Fig. 4)
lDrill as indicated on the scheme and fit two dowels, two hooks and two screws 5x45. (Fig. 4)
Fig. 4
lHang the hood, adjust the position using the screws on the hooks of the hood. (Fig. 5)
lRelease the grease filters. (Fig. 1)
Fig. 5
lFrom the inside of the hood mark on the wall the point corresponding to the hole which will be used to fix definitively the hood. (Fig. 6)
lRemove the hood.
lDrill two hole (Ø 8mm) and fit two dowels.
(Fig. 6)
l Hang the hood again on the hooks.
lFrom inside of the hood insert the definitive fixing screws. (Fig. 6)
Fig. 6
44