Electrolux EFC 9418 user manual What to do if, Special Accessories, Technical Specifications

What to do if

If your appliance fails to work properly please carry out the following checks.

Symptom	Solution
The cooker hood will not start...	Check that: The hood is connected to the electricity supply.
	Check that a fan speed has been selected
The cooker hood is not working	Check that: The fan speed is set high enough for the task.
	The grease filters are clean.
	The kitchen is adequately vented to allow the entry of fresh air.
	If set up for recirculation, check that the charcoal filter is still effective.
	If set up for extraction, check that the ducting and outlets are not
	blocked.
The cooker hood has	The safety cut-out device has been tripped.
switched off during operation...	Turn off the hob and then wait for the device to reset.
	If the hood has been installed below the heights indicated in the
	installation instructions the motor will cut-out frequently which will
	damage the hood.

If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model and serial number.

Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

Special Accessories

Charcoal Filter Type 200

Technical Specifications￿

Model	EFC 9418
Dimensions (in cm):
Height	84-117
Width	89,9
Depth	51,5
Maximum absorbed power:	200 W
Motor absorption:	160 W
Lighting:	2 x 20 W
Length of the cable:	150 cm
Electrical connection:	220-240 V - 50/60 Hz.

Subject to change without notice.