36electrolux
INSTALLATION
Location
Take utmost care when handling your appliance so as not to
cause any damages to the cooling unit with consequent possible fluid leakages.
•During normal operation, the condenser and compressor at the back of the appliance heat up considerably. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. See installation instructions.
•Important: if the supply cord is damaged, it must be replaced by a special cord or assembly
Positioning
•Unpack the cabinet and check that it is in good condition and free of any transport damage.
•Place the refrigerator away from direct sunlight and heat sources.
•Avoid prolonged exposure of the appliance to direct sunlight.
•For safety reasons, minimum ventilation must be as shown in Fig.
50 mm | min. 200cm2 |
| |
| min. |
| 200cm2 |
D526 |
|
Attention: keep ventilation openings clear of obstruction.
•It is necessary that the niche is provided with a conduct of ventilation having the following dimensions:
Depth
Width
The climate classification can be found on the rating plate, which is located inside the cabinet on the left hand wall.
The following table shows which ambient temperature is correct for each climate classification:
Climate | for an ambient temperature of |
classification |
|
SN | +10 to +32°C |
N+16 to +32°C
ST | +18 to +38°C |
T+18 to +43°C