INSTALLATION
Remove all packaging before positioning the machine.
Positioning
If possible, position the machine next to a water tap and a drain.
The dishwasher features fill and drain hoses which can be turned either to the left or the right to suit the
CA06 |
To make this easier, the hose itself may be turned to the left or the right. In either case, be sure to incorporate the strainer (A) supplied with the machine into the joint. See picture.
installation .
Levelling
Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on the spacers on either side of the cabinet.
Caution: the retaining ring must be correctly fitted to avoid water leaks.
Avoid bends or kinks in the hose which could prevent or slow down the flow of water.
If the machine is connected to new pipes or pipes which have not been used for a long time, you are advised to run the water for a few minutes before
IN11 |
IN12 |
connecting the inlet hose. This will prevent deposits of sand or rust clogging the inlet hose filter.
Water Outlet Connection
The end of the drain hose can be connected as follows:
to the sink outlet siphon, securing it if necessary with a clip;
If the door does not close correctly, loosen or tighten the adjustable support feet, until the machine is perfectly level.
Water Supply Connections
to a wall outlet provided with
The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the floor.
This dishwasher must be permanently plumbed into a cold water supply.
The water pressure must be within the limits given in the technical specifications, as it will not function cor- rectly if pressure is outside these specifications.
Your local Water Authority will advise you on the average mains pressure in your area.
Where the water is supplied via a cold water storage cistern, you can work out the pressure yourself by mea- suring the vertical distance (or «head») between the machine's inlet hose and the outlet from the cold water storage cistern, allowing roughly 1 psi for every 2 feet.
|
| For making the connection |
|
| itself, the coupling nut fitted |
|
| to the machine's supply |
|
| hose is designed to screw |
|
| onto either a 3/4 inch gas |
|
| thread spout, or to a pur- |
| A | pose made |
| tap such as the Press | |
|
| |
CA04 |
| Block. |
PIN07GB
| 21 |
|
|
|
| 4 cm |
Ø |
| 18 | Ø 18 | Ø 21 | min | |
|
| |||||
|
| Ø |
| |||
|
|
|
|
|
| |
|
|
|
|
| + 2 m max | min 30 cm max 100 cm |
CS05 |
|
|
|
|
| |
It makes no difference which way the drain hose faces, either to the right or left of the dishwasher.
Avoid bending or kinking the hose as this could prevent or slow down the discharge of water.
If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided.
Likewise the internal diameter of the couplings used for connection to the waste outlet must be no smaller than the diameter of the drain hose.
Note: The sink plug must not be in place when the machine is draining as this could cause the water to siphon back into the machine.
4
