BUILDING-IN
Building-in features
This dishwasher is designed to be fitted under a kitchen counter or sink.
In either case, it is essential that the recess dimensions
Mounting of decor panel onto the door
The height of the panel depends on the height of the plinth of adjacent kitchen units (see kitchen plinth adjustment).
indicated in the picture are followed.
No further openings for venting of the dishwasher are required, but only to let the water fill and drain hoses and power supply cable pass through.
596 max |
172 |
The panel must be fitted with a handle, as the dish- washer handle will be hid- den by the panel.
| 600 | |
| 596 | |
878 | 820880⎟ | |
⎟ | 555 | |
818 | ||
max |
0 ⎟ 60mm |
| 550 | 30 | |
* | * | ||
| |||
II19 |
|
|
Drill the panel with a Ø 2x12 bit according to the dimensions indicated in the figure.
II28 |
II06 |
Fix the cross bar onto the panel using four 3.5x16 screws provided. Reduce the length of fixing screws according to thickness of panel.
The recess height may be anywhere between 820 and 880 mm from the floor since the dishwasher incorporates levelling feet adjustable over a wide range (max 60 mm).
If for aesthetic matching the panel is provided with a false drawer (fitted or carved on the panel itself), the two brackets provided should also be used.
Adjust the height of the appliance by turning these feet.
A distance of 2 mm should be allowed between the top of the dishwasher and the counter top.
Fitting under a counter (kitchen worktop or sink)
30 40
II17
= | 596 max | = |
546 | ||
|
| 40 |
|
| 30 |
Fix the brackets according to the measurements shown in the figure, by us- ing four 3.5 x 16 screws.
It is absolutely essential that the dishwasher is disconnected from the electricity supply before gaining access to any internal component.
Fit the dishwasher into the appropriate housing space and connect it. Make sure that the water fill and drain hoses and the power supply cable are not bent or kinked.
Fitting the panel onto the door
The door on this model is designed for the overlay of a panel having the following dimensions:
Width: | 596 | mm |
Height: | 644 | to 714 mm max |
Reduce the length of fixing screws according to thickness of panel.
| Mount the decor panel by |
| inserting the two pivots of |
| the |
| ted holes of the door. |
| Lift the decor panel until |
| perfect alignment with the |
| facia panel is obtained: if |
| the two brackets have also |
II12 | been used, they will auto- |
matically enagage in the special holes provided on the dishwasher door.
Thickness: | 20 | mm max |
Weight: | 2 | to 7.5 kg max |
Note:
The panel height should not be more than what indicated, otherwise complete opening of the door will no longer be possible as the panel hits against the dishwasher plinth.
II10 |
Once the correct position has been found, open the door and fasten the decor panel on the lower section by means of the two long 4x40 screws provided, us- ing the holes through the inner door (see fig.).
PII03GB
18
