Check that there is salt and rinse aid

Operating Sequence

1 Check that the filters are clean

(see cleaning instructions)

2 Switch on at the main supply

3 Depress the ON/OFF pushbutton

In the display appears the number of the last pro- gramme selected and the «PROGRAMMES SELEC- TION» pilot light flashes.

4 Check that there is salt and rinse aid

The indicator lights will flash if they need topping up.

7 Starting the wash programme

Open the water tap.

Close the dishwasher door.

An audible signal lasting about 1 second informs you that the programme has started.

If a delayed start has been selected, the dishwasher starts the countdown and the number of hours to go before the programme starts appears in the display. A flashing H indicates that the function is active. Once the set delay has elapsed, the programme starts automatically.

If you wish to interrupt the wash programme at any

time, press the ON/OFF button. To restart the machine, press this button again and the wash programme will resume at the point at which it was interrupted.

5 Load the dishes

Remove larger scraps of food.

Pull the lower basket out and arrange the saucepans, plates and cutlery in it.

Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.

Slide the baskets back into the machine.

Ensure that the spray arms can rotate freely.

6 Measure out detergent

Pour the required amount of detergent into the dispenser according to the indications in the Washing Programmes chart and close the lid.

7 Set the programme

Press the «PROGRAMME SELECTION» button until the number corresponding to the required programme appears in the display. The indicator light continues to flash until the programme is started.

The following options may also be selected:

-ECO DRY: by pressing the relevant button. The pilot light corresponding to the selection made comes on.

-NO DRY: by pressing the relevant button. The pilot light corresponding to the selection made comes on

-UPPER/LOWER: by pressing this button washing can be confined to a single basket. Depress the button until the pilot light corresponding to the basket selected illuminates (upper o lower).

Always remember to load all the dishes into the basket selected if you choose this option.

-DELAY START: by depressing this button the start of a programme can be delayed from a minimum of 1 hour up to 9 hours.

8 At the end of the wash programme

The machine stops automatically. An intermittent audi- ble signal lasting about 5 seconds informs you that the programme has finished. In the digital display ap-

pears . This signal remains until a button is pressed.

Switch of the dishwasher by pressing the ON/OFF button.

Turn off the water tap, and switch off at the mains supply.

Wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved.

Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.

Caution

In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops.

9 Cancel the wash programme

To cancel a wash programme which is running, press the «CANCEL» button until the short «instruction accepted» signal (about 2 seconds) is heard. The two

zeros appear in the digital display indicating that the previous setting has been cancelled and a new programme can now be selected.