Electrolux FAVORIT 88010 Hints for test institutes, Full load 12 standard place settings

Page 35

Hints for test institutes	35

Hints for test institutes

Testing in accordance with EN 60704 must be carried out with appliance fully loaded and using the test programme (see "Washing programmes").

Test in accordance with EN 50242 must be carried out when the salt container and rinse aid dispenser have been filled with salt and rinse aid respectively and using the test programme (see "Washing programmes").

Full load: 12 standard place settings

Amount of detergent required:	5 g + 25 g (Type B)
Rinse aid setting:	position 4 (Type III)

Image 35

Contents

Favorit 88010 Dear Customer Contents Installation instructions Correct use Safety informationSafety information General safetyChild safety InstallationProduct description Up and down scrolling buttons Control panelDisplay How to set the optionsSymbols indicate the options see chart Symbols have the following meaningOption menu Option submenu Press OK / Start to confirm and enter submenuOK / Start button Reset buttonSwitching on for the first time setting the language Set the Multi-tab function see Multi-tab function First useSet the water softener Fill the rinse aid dispenserDishwasher is factory set at level Setting manuallySetting electronically Setting Mmol/lTo fill Use of dishwasher saltBy max Use of rinse aidOnly use branded rinse aid for dishwashers Open the container by pressing the release button aLoading cutlery and dishes Adjusting the dosage of rinse aidDaily use Open the door and slide out the baskets to load the dishes Cutlery basket Lower basketCutlery basket can be opened out If necessary, the beer glass holders can be fol- ded up Beer glasses and champagne glassesUpper basket Maximum height of the dishes Upper basket Lower basket Adjusting the height of the upper basketSpikes folded away more room for serv- ing dishes Raising / lowering the upper basket Use of detergentClose the lid and press until it locks in place This detergent will take effect during the prewash phaseFill with detergent Multi-Tab function Final rinse Drying Degree TypeProgramme description Prewash Main washAny Select and start a washing programmeEnd of the washing programme Cancel a delay start or a washing programme in progressInterrupt a washing programme in progress Unloading the dishwasher Care and cleaningCleaning the filters Clean all filters thoroughly under run- ning water Cleaning the spray arms Prolonged periods of non-operation External cleaning Internal cleaning Frost precautionsWhat to do if Display message and malfunction Possible cause and solutionDisplay message and malfunction What to do ifWash results are not satisfactory Technical dataHints for test institutes Full load 12 standard place settingsExample loading arrangements Levelling InstallationFixing to the adjacent units Water supply connections Water inlet hose with safety valveEnd of the drain hose can be connected in the following ways Water outlet hose connectionThis could constitute a fire hazard through overheating Electrical connectionEnvironment concerns Packaging material Page Page Subject to change without notice