Installation and Connection Instructions
Electrical Connection
| Any electrical work required to install this appliance should be car- |
| ried out by a qualified electrician or competent person. |
1 | WARNING - This appliance must be earthed. |
| The manufacturer declines any responsibility should these safety |
measures not be observed.
Before switching on make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.
To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.
Changing a fuse
The appliance is supplied with a 13amp plug fitted. In the event of hav- ing to change the fuse in the plug supplied, a 13amp ASTA approved (BS 1363A) fuse must be used.
Should the plug need to be replaced for any reason, proceed as described below.
The wires on the mains lead are coloured in accordance with the following code.
Green
& Yellow
BlueBrown
Green and Yellow : Earth
Blue | : Neutral |
Brown | : Live |
Cord Clamp
•The wire coloured green and yellow must be connected to the termi-
nal marked with the letter “E“ or by the earth symbol 
or coloured green and yellow.
•The wire coloured blue must be connected to the terminal “N“ or col- oured black.
•The wire coloured brown must be connected to the terminal marked “L“ or coloured red.
•Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.
1WARNING! A cut off plug inserted into a 13 amp socket is a seri- ous safety (shock) hazard. Ensure that, if it is necessary to cut off the plug, it is disposed of safely and not retained.
36