Electrolux ESI 602 manual Before use, Setting the water softener, Filling with salt, To fill

Before use

Before using your dishwasher for the first time:

1.Ensure that the electrical and water connections comply with the installation instructions

2.Remove all packaging from inside the appliance

3.Set the water softener

4.Pour 1 litre of water inside the salt container and then fill with salt

5.Fill the rinse aid dispenser.

6.Run a "Rinse and Hold" programme.

Setting the water softener

The dishwasher is equipped with a water softener designed to remove minerals and salts from the water supply, which would have a detrimental or adverse effect on the operation of the

Filling with salt

Only use salt specifically designed for use in dishwashers.

All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener.

Only fill with salt just before starting one of the complete washing programmes. This will prevent any grains of salt

or salty water, which may have been spilled, remaining on the bottom of the machine for any period of time, which may cause corrosion.

To fill:

1.To fill with salt, unscrew the cap of the salt container.

2.Pour 1 litre of water inside the container (this is necessary only before filling with salt for the first time).

appliance.

The higher the content of these salts, the harder your water is.

Water hardness is measured in equivalent scales, Clarke,

French degrees and PPM (parts per Million).

		Water hardness
	Clarke	French	PPM	Level	Use of
	degrees	degrees	(Parts per
		(°TH)	Million)		salt
0 - 6		0 - 8	0 - 80	0	NO
7 - 14		9 - 20	81 - 200	1	YES
15 - 28		21 - 40	201 - 400	2	YES

3.Using the funnel provided, pour in the salt until the container is full.

Do not worry if water over flows from the unit when filling with salt, this is quite normal.

4.Replace the cap making sure that there is no trace of salt on the screw thread or on the gasket.

5.Screw on the cap tightly.

SALET

SAL

SALZ

SEL

SR06

29	- 42	41	- 60	401	- 600	3	YES
43 - 56		61	- 80	601	- 800	4	YES
57 -	63	81 - 90		801 - 900		5	YES

The softener should be adjusted according to the hardness of the water in your area. Your local Water Authority can advise you on the hardness of the water in your area.

The dishwasher is factory set at level 2.

If this level is not suitable for your area the softener should be adjusted.

If your water is level 0 it is already soft and therefore there is no need to use salt.

In this case adjust the water softener on level 1 without using salt.

To adjust the water softener

With a screwdriver turn the selector on the upper front corner of the machine until the level required corresponds with the marker.

3	4
	5
	1
AA05

The salt container will require topping up periodically.

The salt cap has a refill indicator window in the centre.

A green float is clearly visible when there is salt inside the container, and almost disappears when the salt has finished reminding you to add salt.

SR11

5