12electrolux first use
The water softener must be set in both ways: manually, using the water hardness dial and electronically, using the programme knob and the start/cancel button.
Setting manually
The dishwasher is factory set at position 2.
1.Open the dishwasher door.
2.Remove the lower basket from the dishwasher.
3.Turn the water hardness dial to position 1 or 2 (see table).
4.Replace the lower basket.
Setting electronically
The dishwasher is factory set at level 5.
1.The dishwasher must be switched off.
Keep the start/cancel button pressed and turn the programme knob clockwise until the programme marker corresponds with the first washing programme.
2.Release the start/cancel button, the On/Off and start/cancel indicator lights start to flash indicating that you have activated the water softener setting function.
3.At the same time, the end of programme indicator light starts to flash.
The current level is indicated by the number of flashes of the indicator light end of programme and a pause of about 3 seconds.
Examples:
5 flashes, pause, 5 flashes, pause, etc... = level 5
6 flashes, pause, 6 flashes, pause, etc... = level 6
4.To change the level, press the start/cancel button. Each time the button is pressed the level changes.
Examples:
if the current level is 5, by pressing start/cancel button once, level 6 is selected.
if the current level is 10, by pressing start/cancel button once, level 1 is selected.
5.To memorise the operation, switch off the dishwasher by returning the programme knob to the Off position.