Electrolux ESF 43010 Installation, Fitting under a counter kitchen worktop or sink, Levelling

Page 33

Installation

Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person.

Remove all packaging before positioning the machine.

If possible, position the machine next to a water tap and a drain.

Fitting under a counter (kitchen worktop or sink)

By removing the machine’s worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture.

installation electrolux 33

Proceed as follows:

●Remove the machine’s worktop by unscrewing the two rear retaining screws, pull the worktop from the back of the machine and slide out the front slots, lifting the worktop.

Insert the machine after adjusting the levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.

During all operations that involve accessibility to internal components the dishwasher has to be unplugged.

Be sure that once the appliance has been installed, it is easily accessible for the service engineer in the event that a repair is required.

If the dishwasher is later used as a free-standing appliance, the original worktop must be re-mounted.

The plinth on free-standing appliances is not adjustable.

Levelling

Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on either side of the cabinet.

If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.

Page 32 Page 34
Image 33
Page 32 Page 34
Contents
Dishwasher ESF We were thinking of you Welcome to the world of Electrolux Contents General safety Safety informationChild safety Correct useInstallation Product description Control panel Wash Dry End of programme Salt Rinse aid Indicator lightsProgramme knob and On/Off indicator light Water hardness Adjusting the water Hardness setting Mmol/l First useUse Salt Setting manually Dishwasher is factory set at position Setting electronically Dishwasher is factory set at levelExamples To fill Filling with dishwasher saltFilling with rinse aid Loading cutlery and dishes Daily useElectrolux daily use Lower basket Upper basket Maximum height of the dishes Upper Basket Adjusting the height of the upper basketLower Basket To move to the higher position proceed as followsFill with detergent Use of detergentUse of combi detergent tablets Detergent tabletsSetting and starting the programme with delay start Cancelling the delay startSelect and start a washing programme End of programme indicator light will illuminate Cancel a washing programme in progressEnd of the washing programme Unloading the dishwasherProgramme Washing programmesDegree Soil Type of loadCleaning the filters Care and cleaningFrost precautions External cleaningNever try to remove the upper spray arm Prolonged periods of non- operationSolution Fault codeSomething not working MalfunctionFault code Malfunction Wash results are not satisfactory Dishes are not clean Dishes are wet and dullTechnical data Programme Duration Minutes Consumption values ProgrammeEnergy Consumption KWh Water Consumption LitresHints for test institutes Full load 9 standard place settingsFitting under a counter kitchen worktop or sink InstallationProceed as follows LevellingLocknut must be correctly fitted to avoid water leaks Water supply connectionsWater inlet hose with safety valve Water outlet hose connection Installation electrolux Environment concerns Packaging materialOld appliance Belgium Guarantee/Customer ServiceElectrolux Service Address for our consumer services department BelgiumLuxembourg European guaranteeAlbania Belgique/België/Belgien Page 117997 92/0-01-04092006
Top Page Image Contents