Installation
Levelling
The appliance must be level. Level the appliance by adjusting the two adjustable feet (1) at the front of the appliance.
If required the washer (2) can be removed.
Reversing the Door
The side at which the door opens can be changed from the right side (as supplied) to the left side, if the installation site requires.
Warning! When changing the side at which the door opens, the appliance must not be connected to the mains. Remove plug from the mains beforehand.
Carefully tilt the appliance to the back and place an adequate object under it.
Take care to avoid the
compressor or the condenser touching the ground.
Unscrew the adjustable feet situated on both sides (2
pieces), in addition the screws fixing the lower door holders (2 pieces) respectively the screw
on the other side.
Take off the freezer door by pulling it slightly downwards.
Unscrew the top door hinge pin of the refrigerator then screw it back on the other side.
Fit the freezer door on the upper door hinge pin.
Put over the pin in the lower door holding plate in the direction of the arrow.
Fix the plate on the other side leaving the position of the door unchanged.
10