10Operation
Halogen Bulbs
This range hood requires two halogen bulbs (Type JC, 12Volt, 20Watt Max,
WARNING
Always switch off the electrical supply before carrying out any operation on the appliance.
Figure 2
FUSE
ELECTRICAL | Figure 3 |
BOX |
|
To change bulbs:
1Open the cover by prying from the proper slots.
2Remove the bulb by pulling sideways. (DO NOT ROTATE).
3Replace with Type JC, 12Volt, 20 Watt Max,
CAUTION
Bulb may be hot.
Fuse Placement
CAUTION
Use of bulbs greater than 20 watts will cause the fuse to open.
IF LIGHTS FAIL TO OPERATE, DISCONNECT POWERAT THE SERVICE ENTRANCE. CHECK THE FUSE AND REPLACE IF NECESSARY.
1Raise or remove the lower decorative flue. See Figure 3.
2 Remove the cover from the electrical box.
3 Unscrew the cap from the fuse holder and remove the fuse.
4Replace the fuse with the same size and amperage (5 x 20mm, 4 amp, 125 volt).
CAUTION
Use of a fuse greater than 4 amps may damage the transformer.
5Reinstall the fuse holder cap, electrical box cover and flue.
6 Reconnect power at the service entrance.