Installation 17
Non-Ducted Hoods Only
NOTE
The following materials must be purchased separately for
•
• 5” diameter duct.
1 Remove the tape on the electrical system plate; place the electrical system plate on the hood (use a protection). Figure 12
2Discard discharge collar/damper supplied with the hood. Install the 5” to 6” adapter supplied with the
3 Secure the plenum to the flue mounting bracket with (2) 3.9x6mm flat head screws (the screws are supplied with the
ELECTRICALADAPTER SYSTEM
PLATE
3.9x6mm | FLUE MOUNTING |
FLAT HEAD | BRACKET |
SCREWS |
|
PROTECTION | Figure 12 |
|
PLENUM
Figure 13