20Installation
INSTALL THE FILTERS
Ducted and Non-Ducted Hoods
1To remove the GREASE filter, push in on the metal latch tab and tilt filter downward to remove.
2To install the GREASE filter, align rear filter tabs with slots in the hood. Depress the metal latch tab, push filter into position and release. Make sure filter is securely engaged after installation.
NOTE
Prior to use, remove protective film from the filter frame.
Non-Ducted Hoods Only
1 To remove the CHARCOAL filter, push in on the front filter latch. Pull the filter down to disengage the rear filter tabs.
2 To install the CHARCOAL filter, align the rear filter tabs with slots in the hood. Push the filter up into place until the front latch snaps securely into the slot. Make sure the filter is securely engaged after assembly.
3Install GREASE filter after charcoal filter is installed.
Figure 18
TABS
LATCHNON-DUCTED RECIRCULATION
FILTER
Figure 19