Emerson 5081-P-FF/FI Sensor Wiring And Set-Up, Wiring Through A Junction Box, Power Wiring

MODEL 5081-P-FF/FI

SENSOR WIRING AND SET-UP

Wire sensor per Figure 1. Refer to the sensor instruction manual for more details.

If your sensor has an integral preamplifier or you are using a remote preamplifier, you will need to change the pream- plifier location in the program menu. Please see Figure 14. Select “trAnS” for integral preamplifier or “SnSr” for J-box or sensor preamplifier.

WIRING THROUGH A JUNCTION BOX WITH REMOTE PREAMPLIFIER

Wire sensor as shown in Figure 5. Refer to the sensor instruction manual for more details.

WIRING

WIRING THROUGH A JUNCTION BOX

Sensors with integral preamplifiers can be wired to the ana- lyzer through a remote junction box (PN 23550-00). Wire the extension cable and sensor cable point-to-point. Refer to the sensor instruction manual for more details.

POWER WIRING

For general purpose areas, wire power as shown in Figure 1. For hazardous areas, please see hazardous area installation drawings.

(9 - 32 VDC)

NOTE: REF wire covered with sleeving. To prevent depletion of KCL if other wires touched, remove sleeving before wiring to TB-7.

FIGURE 1. Model 5081-P-FF/FI Wiring Details

3