Electrolux ES200 Adjusting Your Oven Temperature, Changing the Oven Light some models

Page 18

Care & Cleaning

Changing the Oven Light (some models)

The oven light automatically turns ON when the door is opened. The oven light may also be manually operated by pressing the oven light switch located on top of the control panel.

The oven light bulb is located at the rear of the oven and is covered with a glass shield held by a wire holder. The glass shield must be in place whenever the oven is in use.

To replace the oven light bulb:

1. Turn electrical power off at the main source or unplug the range.

2. Press wire holder to one side to release the glass shield.

3. Replace bulb with a new 40 watt appliance bulb.

4. Replace glass shield over bulb and snap wire holder into place.

5. Turn power back on again at the main source (or plug the range back in).

6. The clock will then need to be reset. To reset, see Setting the Clock and Minute Timer in this Use & Care Manual.

Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather-faced glove for protection against possible broken glass.

Care and Cleaning of Stainless Steel (some models)

Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the appearance of stainless parts. Refer to the Care & Cleaning Table for detailed cleaning instructions.

Adjusting Your Oven Temperature

Your oven control has been precisely set at the factory. This setting may differ from your previous oven however, so your recipe times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe times, you can adjust the control so that the oven cooks hotter or cooler than the temperature displayed.

To Adjust Oven Temperature:

1.Press .

2.Set the temperature to 550°F (287°C) by pressing and holding the .

3.Within 2 seconds, press and hold until the 2 digit display appears. Release. The display now indicates the amount of degrees offset between the original factory temperature setting and the current temperature setting. If the oven control has the original factory calibration, the display will read "0."

4.The temperature can now be adjusted up or down 35°F (17°C), in 5°F steps by pressing and holding the or . Adjust until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign (-) will appear before the number to indicate that the oven will be cooler by the displayed amount of degrees.

5.When you have made the desired adjustment, press to go back to the time of day display.

Note: Oven temperature adjustments made will not change the Self-Cleaning feature temperature.

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents
Warranty Back Important Safety InstructionsBefore Setting Oven Controls Setting Surface Controls Before You CallWelcome & Congratulations Register Your ProductImportant Safety Instructions Important Instructions for Usingyour Cooktop Important Safety NoticeFeatures At a Glance Your Electric Range Features Include1921 Before Setting Oven Controls About the Radiant Surface Elements Element On & Hot Surface Indicator LightsAbout the Ceramic Glass Cooktop Cookware Material TypesSuggested Radiant Surface Element Settings Table Setting Surface ControlsUsing proper cookware To Operate Single Radiant Surface ElementsTemperature conversion Oven Control FunctionsTo Change the Minute Timer while it is in use Setting Oven ControlsTo Set the Minute Timer To Set the ClockTo Set or Change the Temperature for Baking To Set Control for Continuous Bake or 12 Hour Energy SavingTo Set Control for Oven Lockout To Set for Broiling Self-Cleaning Self-Cleaning OvenAdhere to the following cleaning precautions Stopping or Interrupting a Self-Cleaning Cycle Starting the Self-Clean CycleTo Set the Controls for a Self-Clean Cycle When the Self-Clean Cycle has CompletedCare & Cleaning Surfaces How to CleanCooktop Cleaning & Maintenance Plastic or foods with a high sugar contentFor heavy, burned on soil To Remove Oven Door Special Caution for Aluminum Use on the Ceramic CooktopRemoving and Replacing the Lift-Off Oven Door To Replace Oven DoorTo Adjust Oven Temperature Adjusting Your Oven TemperatureCare and Cleaning of Stainless Steel some models Changing the Oven Light some modelsSolutions to Common Problems Before You CallOven light does not work Page Page Page Limitedwarranty