Electrolux EKM6045, EKM6044 Moving Your Appliance, For Your Safety, Location of Appliance

Page 31

MOVING YOUR APPLIANCE

You may damage some soft or badly fitted floor coverings when you move the appliance. The floor covering under the appliance should be securely fixed so it does not ruck up when you move the appliance across it. Alternatively you could remove the floor covering. This appliance is heavy and care must be taken when moving it. Do not try to move the appliance by pulling the door handles.

To move the appliance open the grill door. Raise the appliance off its front feet by lifting it from inside the oven. Pull the appliance forward. When you replace the appliance push it back to the stop and make sure there is the same gap at each rear corner.

FOR YOUR SAFETY

Do not try to disconnect the appliance from the gas supply if the supply pipe does not have a bayonet connection, as described in the installation instructions. If this is the case contact the person who installed the appliance.

LOCATION OF APPLIANCE

This appliance must not be installed in a bed-sitting room of volume less than 20m3 or in a bathroom, shower room or garage. It is essential that the appliance is positioned as Fig 1. a. Shelves, wall cabinets and cooker hoods must be fitted a minimum of 750mm directly above the top of the hotplate (or greater for cooker hoods if recommended by manufacturers instructions) and 400mm above the hotplate when fitted in line with the outside of the appliance. If the units are intended to be fitted adjacent to the appliance but less than 400mm above the hotplate, then a minimum space of 50mm must be maintained between the sides of the unit and the appliance as Fig 1.b. Curtains must not be fitted immediately behind the appliance or within 150mm of the sides of the hotplate. If fitted next to or between two base units a minimum space of 2mm must be left between each unit and the sides of the appliance. The levelling feet fitted to the appliance will achieve a nominal height to hotplate of 900mm + 20mm.

Note:- L.P.G. cookers MUST NOT be installed below ground level i.e. in a basement or aboard any boat, yacht or other vessel.

LEVELLING THE APPLIANCE

Adjustment to suit floor conditions or height is obtained by rotating clockwise or anti clockwise the feet at the front and rear of the appliance. A spirit level should be placed on one of the shelves to confirm the appliance is correctly levelled.

31

Fig 1.a

Fig 1.b

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Model EKM6044 / EKM6045 Cleaning and Maintenance Important Safety InformationInstallation Child SafetyContents SLIP-IN Electric Double Oven with GAS HOB Description of the ApplianceGetting to Know Your Appliance Control Panel FeaturesBefore Using the Appliance HOW to SET the Time of DAY TimerHOW to SET the Countdown Setting the Oven Timer Control To Cancel the CountdownTo SET the Timer to Switch on and OFF Automatically Things to Note To SET the Timer to Switch OFF onlyTo Cancel AN Automatic Programme To Return the Appliance to ManualTo Turn OFF ANY Burner Using the HOBGAS HOB To Light the HOB BurnersHints and Tips Ensure the handle is correctly located Using the GrillGrill Grill PAN and HandleGrill Time Grilling ChartFood PositionTOP Oven Using the TOP OvenTo FIT the TOP Oven Shelf Hints and Tips Main Oven Using the Main OvenTo FIT the Main Oven Shelves Hints and Tips FAN Oven TOP Oven Food Position Cooking Approx Temp C Tempc Oven Cooking ChartMeattemperature Roasting ChartUsing Defrost Feature Defrost FeatureCleaning the Control Knobs and Handles Care and CleaningCleaning Materials Cleaning the Outside of the ApplianceWhen Replacing Hotplate Burner Parts Cleaning the HOBAerosol cleaners must not be used on Stayclean surfaces Cleaning Inside the Grill and Oven CompartmentsTo Replace the Outer Glass Cleaning the DoorsCleaning Between the Outer and Inner Door Glass To Remove the Outer GlassReplacing AN Oven Light Bulb Possible Solution ProblemSomething not WORKING? Service and Spare Parts This guarantee does not cover Guarantee ConditionsGeneral DimensionsTechnical Details ConnectionsImportant Safety Requirements Installation InstructionsProvision for Ventilation Levelling the Appliance For Your SafetyMoving Your Appliance Location of ApplianceConnect to 230 240V AC supply only Connecting to the Electricity SupplyEnsure That the Links are Fitted AS Shown Pressure Testing Connecting to GAS SupplyFitting the Stability Chain Checking the TOP Oven Checking the GrillChecking the Hotplate Checking LID SHUT-OFF DevicePage Important Notice
Top Page Image Contents