Electrolux 818 35 94-01/2 manual Frozen Storage, Preparation of Ice Cubes, Tips

Page 25

Tips:

The following are suited for the packaging of frozen goods:

freezer bags and polyethylene wraps;

plastic containers for frozen goods;

extra–thick aluminium foil.

The following are suitable for sealing bags and wrap: plastic clips, rubber bands or tape.

Smooth the air out of the bag before sealing; air makes it easier for the frozen food to dry out.

Make flat packages, because these freeze more quickly.

Do not fill plastic containers for frozen goods to the brim with liquid or paste–like goods, because liquids expand during freezing.

Frozen Storage

Important! Wait until the necessary storage temperature of –18 °C has been reached before storing food already frozen.

Load the freezer only with packaged frozen goods, so that they do not dry out or lose their flavour, and so that no flavour contamina- tion of other frozen goods can occur.

Please observe maximum storage times and expiry dates of frozen goods.

2 Place frozen foods in the drawers sorted by type, as far as possible. This will give you a better overview of the contents, avoid extended door opening and therefore save electricity.

3 From a food safety point of view, -18 °C is deemed sufficient as cold storage temperature.

Preparation of Ice Cubes

01. Fill the ice cube tray 3/4 full with cold water, place it in the freezer and leave to freeze.

2.To loosen the frozen cubes, either bend the ice cube tray or hold it under running water for a few seconds.

Important! Never try to free an ice tray that is frozen to the freezer compartment using pointed or sharp edged objects. Use a soft plastic scraper.

818 35 94-01/2

25

Image 25 Contents
Arctis Dear customer Contents What to do if Cooling drinksPrior to Installation Important Safety InstructionsInstallation RefrigerantMaintenance and Cleaning Child SafetyDuring Use ServicingAppliance Transport Environmental InformationPackaging material Old applianceFitting the Door Handle Before UsePackaging Dle bracket on the lower left-hand side of the doorInstallation Location InstallationA higher power consumption see also Something not working Freezer needs ventilationElectrical Connection Appliance AlignmentEarth Nals in your plug, proceed as fol- lowsRight. Close the door Reversing the doorMove the upper hinge bracket pivot to the left Reversing the door No-frost frost free system View of the appliance Description of the applianceCold accumulation block These buttons are connected to the temperature display Temperature setting buttonsControl Panel Temperature display TURBO/FROSTMATIC-button Alarm OFF buttonInitial use Prior to Initial Start-UpRemove the cold accumulation block from the appliance Select Freezing or Cooling Temperature Adjustment Switching the Appliance Off Red warning indicator will go out when the door is closed Temperature WarningControl and Information Systems Open Door WarningFunction Errors Temperature memoryOpening the door Freezing Only in the operating mode FreezingPreparation of Ice Cubes Frozen StorageTips Maximum Load Storage Goods Symbols/Freezing CalendarCooling Long Fresh CoolingCooling drinks Standard CoolingHints and Tips Energy Saving AdviceNormal Operating Sounds Food StorageInternal Cleaning Maintenance and CleaningExternal Cleaning Correcting Malfunctions What to do ifWhat to do if Replacing the light bulb Regulations, Standards, GuidelinesReplace defective light bulb Place the cover again Refrigerant circuit has been checked for leaksRefrigerant Circuit Technical TerminologyEvaporator CompressorStandard Guarantee Conditions Guarantee Conditions08705 929 Service & Spare PartsCustomer Care Major AppliancesSubject to change without notice