•Do not set temperature any colder than necessary.
•Put frozen food in the fridge to defrost. The cold in the frozen food will then be used to cool the fridge.
Something Not Working
If the appliance is not functioning correctly, please carry out the following checks before contacting your local AEG Service Force Centre.
Warning!
Repairs should only be carried out by qualified service engineers. Repairs carried out by inexperienced persons may cause injury or serious malfunc- tioning.
Symptom |
| Possible Cause |
| Remedy |
|
|
|
|
|
|
| Appliance is not switched on |
|
|
|
|
| Mains plug is not plugged in |
Appliance does not work. |
| or is loose. |
|
| |
| Fuse has blown or is defective. | |
|
| |
|
|
|
|
|
|
|
| Socket is defective. |
|
|
|
|
|
|
Appliance cools too much. |
| Temperature is set too cold. |
|
|
|
|
|
|
| Temperature is not properly | |
|
| adjusted. |
|
|
|
|
| Door was open for an exten- |
|
| ded period. |
The food is too warm. |
|
|
| A large quantity of warm food | |
|
| was placed in the appliance |
|
| within the last 24 hours. |
|
|
|
|
| The appliance is near a heat |
|
| source. |
|
|
|
Interior lighting does not work. Light bulb is defective.
Heavy build up of frost, possi- |
| Door seal is not air tight (pos- |
bly also on the door seal. |
| sibly after reversing the door). |
|
|
|
Switch on the appliance.
Insert mains plug.
Check fuse, replace if neces- sary.
Mains malfunctions are to be corrected by an electrician. Turn the temperature control knob to a warmer setting. Please look in the "Initial Start Up" section.
Open the door only as long as necessary.
Turn the temperature control knob to a colder setting.
Please look in the "Installation location" section.
Please look in the "Changing the Light Bulb" section. Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx. 50 °C). At the same time shape the warmed door seal by hand until it sits cor- rectly.
14