Electrolux C 7 18 41-4i Changing the light bulb, Switch the appliance back on

Page 15

Symptom

The compressor does not start immediately after changing the temperature setting. Water on the floor or on sto- rage shelves.

Possible Cause

This is normal, no error has occurred.

Water drain hole is blocked.

Remedy

The compressor starts after a period of time.

See the "Cleaning and Care" section.

If, after carrying out the necessary checks there is still a fault with your appliance please contact your local AEG Service Force Centre.

In guarantee customers should ensure that the suggested checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

Please note that proof of purchase is required for any in-guarantee service calls.

Changing the light bulb

Warning! There is a risk of electric shocks! Before changing the light bulb, switch off the appliance and unplug it. Light bulb data: 220-240 V, max. 15 W

1.To switch off the appliance, turn the temperature control knob to position "0".

2.Unplug the mains plug.

3.To change the light bulb, remove the screw from the light bulb cover.

4.Unhook the light bulb cover as shown.

5.Change the defective light bulb.

6.Refit the light bulb cover and the screw.

AEG65

7.Switch the appliance back on.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Santo C 7 18 Who thinks ecologically acts accordingly Dear customerContents Prior to Initial Start-up SafetySafety of Children Intended UseAppliance Packaging Information ServiceDisposal Daily OperationRemove Transport Packaging Description of the applianceShelf holders Low Room Temperature Switch Starting Up and Temperature RegulationVariable Inner Door Interior AccessoriesFresh Food Refrigeration Storage ShelvesFreezing and Storing Frozen Food Ice Pack Preparation of Ice CubesThere are two ice packs in one drawer of the freezer Storage Goods Symbols/Freezing Calendar Symbols on the drawers show different types of frozen goodsDefrosting Cleaning and Care Switching off the applianceEnergy Saving Tips When everything is dry switch the appliance back onSomething Not Working Symptom Possible Cause RemedyChanging the light bulb Switch the appliance back onCustomer Care Department Service and Spare PartsGuarantee Conditions Electrical Connection InstallationPositioning Your Appliance Needs AirReversing the Door Width Housing DimensionsHeight DepthInstructions for Building-in 50mm Fix cover C on guide a until it clips into place Fix cover D on guide B until it clips into place Regulations, Standards, GuidelinesPage Page Page AEG
Top Page Image Contents