Electrolux C 7 18 41-4i installation instructions Fix cover C on guide a until it clips into place

Page 23

Fix cover (C) on guide (A) until it clips into place.

A

C

PR33

Open the appliance door and the fur- niture door at 90°. Insert the small square (B) into guide (A). Put togeth- er the appliance door and the furni- ture door and mark the holes as indi- cated in the figure. Remove the squares and drill holes with ø 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied.

At the end of installation/adjusting, it is necessary to check if the door of the furniture closes properly.

Should adjustment of the furniture door be necessary, use the clearance of slots.

	8mm
	A
PR167	B
PR167

PR168

23

Image 23

Contents Santo C 7 18 Who thinks ecologically acts accordingly Dear customerContents Prior to Initial Start-up SafetySafety of Children Intended UseAppliance Packaging Information ServiceDisposal Daily OperationShelf holders Remove Transport PackagingDescription of the appliance Low Room Temperature Switch Starting Up and Temperature RegulationVariable Inner Door Interior AccessoriesFresh Food Refrigeration Storage ShelvesFreezing and Storing Frozen Food There are two ice packs in one drawer of the freezer Ice PackPreparation of Ice Cubes Defrosting Storage Goods Symbols/Freezing CalendarSymbols on the drawers show different types of frozen goods Cleaning and Care Switching off the applianceEnergy Saving Tips When everything is dry switch the appliance back onSomething Not Working Symptom Possible Cause RemedyChanging the light bulb Switch the appliance back onCustomer Care Department Service and Spare PartsGuarantee Conditions Electrical Connection InstallationReversing the Door PositioningYour Appliance Needs Air Width Housing DimensionsHeight DepthInstructions for Building-in 50mm Fix cover C on guide a until it clips into place Fix cover D on guide B until it clips into place Regulations, Standards, GuidelinesPage Page Page AEG