Electrolux CI 800 FA user manual Control panel

Page 4

4electrolux

Environment Protection

This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be dis- carded together with the urban refuse and rubbish. The insulation foam con- tains flammable gases: the appliance

shall be disposed according to the ap- plicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable.

Control panel

1

2

3

4

5

1Pilot light

2Temperature regulator

3Action Freeze light

4Action Freeze switch

5Alarm light

Switching on

Insert the plug into the wall socket.

Turn the Temperature regulator clockwise to a medium setting.

The pilot light will light up.

Important! If the temperature inside the appliance is too high the Alarm light will blink. Active the Action Freeze function.

Switching off

To turn off the appliance, turn the Tempera- ture regulator to the "O" position.

The pilot light will switch off.

Temperature regulation

The temperature is automatically regulated. To operate the appliance, proceed as fol- lows:

turn the Temperature regulator toward lower settings to obtain the minimum cold- ness.

turn the Temperature regulator toward higher settings to obtain the maximum coldness.

A medium setting is generally the most suitable.

However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on:

room temperature

how often the door is opened

the quantity of food stored

the location of the appliance.

Important! If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption.

Action Freeze function

You can activate the Action Freeze function by pressing the Action Freeze switch.

The Action Freeze light will light up.

This function stops automatically after 52 hours.

It is possible to deactivate the function at any time by pressingAction Freeze switch.

The Action Freeze light will switch off.

Excessive temperature alarm

An increase in the temperature in a compart- ment (for example due to an power failure) is indicated by flashing of the Alarm light.

When normal conditions are restored the Alarm light will switch off automatically.

Image 4
Contents Freezer CI 800 FAElectrolux. Thinking of you Contents Safety informationCare and cleaning InstallationService Daily UseControl panel Daily use First useHelpful Hints and Tips Care and cleaning Periodic cleaningHints for storage of frozen food Defrosting the freezerPeriods of non-operation What to do if…Disconnect the appliance from elec- tricity supply Technical data Closing the doorInstallation PositioningElectrical connection Door reversibilityInstalling the appliance 50-min. cm2HaHb Environmental concerns Electrolux Electrolux Electrolux 212714121-00-16102009