Electrolux 66050i Electrical Connection, As the colours of the wires in the mains lead

BROWN

CORD CLAMP

The mains cable may only be changed by a qualified electrician or competent person. If your appliance needs repairing, please contact your local AEG Service Force Centre.

Electrical Connection

Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

WARNING – THIS APPLIANCE MUST BE EARTHED

The manufacturer declines any liability should these safety mea- sures not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is inside, on the left.

The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.

Important

GREEN & YELLOW

13 AMP. FUSE

The wires in the mains lead are coloured in accordance with the

following code:

Green and Yellow Earth

BlueNeutral

BrownLive

BLUE

13 AMP

As the colours of the wires in the mains lead 207

of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

1.The wire coloured green and yellow must be connected to the termi-

nal marked with the letter “E” or by the earth symbol or coloured green and yellow.

2.The wire coloured blue must be connected to the terminal marked “N” or coloured black.

3.The wire coloured brown must be connected to the terminal marked “L” or coloured red.

4.Upon completion there must be no cut, or stray strands of wire pre- sent and the cord clamp must be secure over the outer sheath. Warning! A cut-off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut-off plug is disposed of safety.

16