Changing the light bulb

Malfunction	Possible Cause	Remedy


Unusual noises.	Appliance is not level.	Readjust the feet.
	The appliance is touching	Move the appliance slightly.
	the wall or other objects.
	A component, e.g. a pipe,	If necessary, carefully bend
	on the rear of the appliance	the component out of the
	is touching another part of	way.
	the appliance or the wall.
The compressor does not	This is normal, no error has	The compressor starts after
start immediately after chan- occurred.		a period of time.
ging the temperature set-
ting.
Water on the floor or on sto-	Water drain hole is blocked. See the "Cleaning and
rage shelves.		Care" section.

If after all these checks your appliance does not operate correctly, contact your local AEG Service Force Centre.

Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls.

In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

Warning! There is a risk of electric shocks! Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or the cir- cuit breaker. Light bulb data: 220-240 V, max. 15 W

1.To switch off the appliance, turn the temperature regulator to position "0".

2.Unplug the mains plug.

3.To change the light bulb, unscrew the light cover.

4.Unhook the light bulb cover as

shown.

5. Change the defective light bulb.

6. Refit the light bulb cover and the screw.

7.Put the refrigerator back into ope-

ration.D613

Remedy

Changing the light bulb