INSTALLATION INSTRUCTIONS
FLEXIBLE PIPE INSTALLATION
FITTING THE APPLIANCE AND CABINET
It is recommended that a 3/8”, 1100mm long angled flexible hose (BFS), and a ½” straight socket (BFS) be used for the installation. However, any approved hose of the right length can be used.
IMPORTANT: Flexible tubing used must comply with BS 669 current editions. L.P.G. flexible connections must be of a type suitable for L.P.G. and capable of operation up to 50mbar and carry a red stripe, band or label.
NOTE: Only liquid sealants can be used in threaded gas connections. Do Not use P.T.F.E.Tape.
1.Make suitable arrangements for gas and electric supplies into the installation site.
2.When unpacking the appliance keep it on its polystyrene base until it is put into the cabinet to avoid damage.
NOTE: It is imperative that the appliance is left in the base to protect both the appliance and the floor.
3.If the gas supply bayonet and wall fixing bracket are to be located behind the appliance it must be located in the shaded area as indicated in Fig.8.
4.Connect flexible hose to the gas inlet supply block see Fig.8. The hose should be long enough to allow the appliance to be withdrawn from the cabinet.
5.Position the appliance in front of the cabinent and run the supply cable (See Connection to Electricity Supply) through the cabinet and connect to the junction box or socket. Ensure that the supply is isolated at this stage. Connect flexible hose to the bayonet connector.
Fig.8120
580
280
120
35