Electrolux EOB 68713 user manual If something goes wrong, Problem Solution

42electrolux

If something goes wrong

If the oven is not working correctly, please carry out the following checks, before contacting your local customer care department.

IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.

PROBLEM	SOLUTION
„ The oven is not heating up.	‹Touch key , then select a cooking function.

or

‹Has the fuse in the domestic electrical installation been tripped?

or

‹Check whether the appliance is correctly connected and the socket switch or the mains supply to the oven is ON.

or

‹The "Demo" function has been accidentally activated. To deactivate it proceed as follows:

	1. In the Off position press key			for about
	5 seconds. The oven turns to stand by and
	off again. A sound signal will be emitted.
	2. Within 5 seconds press at the same time
	the keys	and	keys and hold them
	pressed until a sound signal will be emitted.
	If the “Demo” word disappears at the next
	switch then operation is successfull.
„ The oven light does not come	‹Select a cooking function.
on.	or
	‹Buy a new oven light bulb; if necessary, order
	from the Electrolux Service Centre and install
	according to the instructions in this user manual.
„ Steam and condensation	‹When the cooking process is completed,
settle on the food and in the	do not leave the dishes standing in the
oven cavity.	oven for longer than 15-20 minutes.

„A fault code (letter F followed ‹Switch the appliance off and on again via the

by digits) appears in the clock	house fuse or the safety switch in the fuse box.
display.	If it is displayed again, please take note of the
	fault code and contact the nearest customer
	care department.