18Installation
Verifying Operation
Warning
•Read the use and care guide completely before operation.
•To keep the grinder from jamming, pour only roasted, unflavored coffee beans into the coffee bean container.
•Plug the coffee maker into the dedicated, properly grounded,
•Test the lights by turning the light switch on and off. It is located on the brewing compartment ceiling, on the far right.
•Turn on the power switch. It is located near the middle of the brewing compartment ceiling.
•On model E24CM76GSS (plumbed model): Turn on the water supply at the
•On model E24CM75GSS (tank model): Fill the tank with filtered water (4 gpg maximum water hardness, do not use distilled water).
• | Push the Hot Water button. Wait about six (6) seconds. |
| |
Hot | |||
|
| ||
• | Continue to push the hot water button every six (6) seconds until | Water | |
| air bubbles no longer come out of the dispenser and about six (6) |
| |
| ounces of water is dispensed. |
|
•Clean the coffee system according to the Routine Cleaning and Flushing Out the Coffee Maker sections in the use and care guide. On model E24CM75GSS, clean the water tank.
•Put a sauce pan under the drink dispenser.
•Make one of each type of drink in the Operation Instructions section of the use and care guide.
If the coffee maker does not operate properly, follow these troubleshooting steps:
1.Verify that power and water are being supplied to the coffee maker. On model E24CM75GSS, make sure the water tank is full.
2.Make sure that the coffee bins have been properly filled according to the use and care guide.
3.Check the regulator to make sure it is properly adjusted. Air in the system during initial operation can cause the initial adjustment to be incorrect.