Setting the Programme Time

This feature allows you to pre-programme brewing for the desired time. By pressing the ’Programme’ button the digital display shows the current programme time. This default setting is 12:00pm.

Entering “Set Programme Time” mode:

Press and hold the “Programme Set” button until the green light and LCD display begin to flash, this signals that you have entered the “Set Programme Time” mode. The desired time can be set by pressing the “Hours” and “Minutes” buttons to scroll forward through the digits. The buttons can be held down to scroll through the digits or pressed and released lightly to advance one digit at a time. The coffee maker will start to brew at the programmed time.

N.B. The “Programme” mode cannot be entered if the coffeemaker is in a “brew” cycle.

N.B. When setting the programme time, ensure coffee and water are placed in the machine before the automatic start (see “Preparing to Brew”)

Exiting “Set Programme Time” mode:

There are 3 ways to exit the “Set Programme Time”:

ßPress the “Programme” button, this acts as a “cancel” button and will cause the coffeemaker to revert to its previous state. If it was OFF, it will return to the OFF position. If “Programmed” it will revert to this state, and so on. This is a safety feature.

ßPress any other button (except “Hours” or “Minutes”). “Set Programme Time” mode will be exited and the function of that button will be activated.

ßLeave the control. If neither “Hours” nor “Minutes” button is pressed for a period of 5 seconds, the “Set Programme Time” mode will be exited automatically and the programmed setting will be in effect.