Viking 201, 301 manual Custom Door Panel, Use non-marring clamps to hold custom panel in place

Custom Door Panel

(Specifications for FDB301/FDB451 Models)

Custom Door Panel (Installation Option)

Locator

	ø1/8” 4 places
	(0.3 cm)
		29-3/4”
14”		(75.6 cm)
(35.6 cm)		to
		31-1/4”
	22-5/32”	(79.4 cm)
	(56.3 cm)

13-1/2”

Have the overlay panel constructed per dimensions. The panel thickness MAY NOT exceed 3/4" (1.91 cm) for flush installation in most cabinets. Ensure that the design, construction, and installation of the panel overlay and its handle mounting is sufficient to reliably operate in this application with a maximum panel weight of 18 lbs. (8.2 kg.) Custom panels should not exceed 18 lbs. (8.2 kg.)

1	Locators
	2
	2

		4
1	x2	x2
		3

Pre-drill two holes with 1/8” drill bit for the locators using dimensions shown in the figure. Attach plastic locators using the Torx (T20 BIT) pan head screws provided in the hardware package.

2

x4

Pre-drill other four locations for wood screws to attach the panel to the dishwasher door using the dimensions shown in the figure.

(34.3 cm)

10-5/8”

(27.0 cm)

22-21/32”

(57.5 cm)

23-9/32"with trim

(59.1 cm)

or

23-7/8” without trim

3

1

1

4

1

1 1

1

x4

2

(60.6 cm)

Note: Back side of panel shown. Use caution not to drill through front of panel.

Note: If panels are made longer than 29-3/4” (75.6 cm), the door panel will be taller than dishwasher control panel.

Note: All hole location dimmensions should be measured from the bottom of the door per the illustration above.

Use locators to align the panel to the	Use non-marring clamps to hold custom panel in place.
dishwasher door holes.	Use the truss head 1-3/4” long screws provided in the
	hardware package for the panel attachment.

Note: If you are using any special panel material

and that require special screws, always use a #8 1-3/4” long truss head Torx stainless steel screws. The screws MUST BE stainless steel to avoid corrosion.

8 9