Viking 201, 301 manual Electrical Connections, Remove front plate, Cable from terminal block, White

Electrical Connections

Hardwire Conduit Option (201 & 301 Models)

1 2

Grounding Instructions

This appliance must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current. This appliance is equipped with a cord having an equipment- grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local codes and ordinances.

Disconnect the electrical power supply and place a tag at the disconnect switch indicating that you are working on the circuit.

Grounding Instructions if Hardwired: This appliance must be connected to a grounded metal, permanent wiring system; or an equipment grounding conductor must be run with the circuit conductors and connected to the equipment – grounding terminal or lead on the appliance.

•For a cord connected undercounter dishwasher:

1.The power supply receptacle for the appliance should be installed in a cabinet or on a wall adjacent to the under counter space in which the appliance is to be installed;

2.There should be an opening through the partition between the compartments mentioned in Item (1), that is large enough for the attachment plug to pass through. The longest dimension of the opening shall not be more than 1-1/2” (38 mm).

3.The edges of the opening mentioned in Item (2) should, if the partition is wood, be smooth and rounded or, if the partition is metal, be covered with the grommet provided for this purpose by the manufacturer; and

4.Care should be exercised, when the appliance is installed or removed to reduce the likelihood of damage to the power supply cord.

•The dishwasher comes with a 3’9” (1.1 m) electrical cord for 110-120 volts, 15/20 amp supply. This cord should be plugged into the 110-120 volt outlet located under the sink.

•If the cord is not long enough or if a hard wire installation is needed, follow the instructions in the “Hardwire” section.

Note: Access holes should be 2” square (5.1 cm) with no sharp edges.

•In a hardwire installation, use only copper supply conductors. The conductors should have a minimum temperature rating of 194° F (90° C).

Be sure electrical power is turned off at circuit breaker or fuse box before servicing or installing unit. Do not use an extension cord for this appliance.

Improper connection of the equipment – grounding conductor can result in a risk of electric shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the appliance is properly grounded. Do not modify the plug provided with the appliance; if it will not fit the outlet, have a proper outlet installed by a qualified electrician.

		3
		2
	1	x4
Remove any loose items in the dishwasher and carefully	Remove bottom pan. Note: Rapid removal of the bottom pan will
lay the dishwasher on its back. Note: Be careful not to	cause damage to the moisture sensor. For installation and servicing,
pinch hoses or power cord beneath dishwasher.	slowly pull the bottom pan from the unit and disconnect the wire
	from the moisture sensor, which is located in the center of the pan.
3	4
3

1

x2

2
Remove front plate.	Remove factory installed power
	cable from terminal block.

5 6

		Black
		(Line)
		1
		1
1	2	2
		White
		(Neutral)

Attach UL approved 3/4” strain relief (not included) to	Connect wires to terminal block.
bottom of terminal box. Run wires through strain relief.

12 13